0.56 Inch 4 Digit 7 Segment LED Displays, Red Color

Reference: RBD-1251

7 Inch TFT IPS Monitor for Raspberry Pi

7-inch TFT color monitor VGA HDMI 1024*600 for Raspberry Pi  TFT IPS LCD with 1024 X 600 resolution This is a 7-inch IPS LCD screen with a resolution of 1024 X 600 and can be used as a monitor for Raspberry Pi 3 and Raspberry Pi 4. It works with Raspberry pi easily does not require any additional modification of raspbian boot Image.

Reference: RBD-1219

3.5inch Arduino Display-UNO

Product Description Supports development boards such as Arduino UNO and Mega2560 for plug-in use without wiring 480X320 resolution, clear display, support for touch function Support 16-bit RGB 65K color display, display rich colors 8-bit parallel bus, faster than serial SPI refresh On-board 5V/3.3V level shifting IC, compatible with 5V/3.3V operating...

Reference: RBD-914

Max7219 4 Channel Dot Matrix Display Panel

MAX7219 Dot Matrix Module Microcontroller 4 In One Display with 5P Line

Reference: RBD-384

MAX7219 Red Dot Matrix Module MCU Control Display Module DIY Kit For Arduino

Soldering is required

Reference: RBD-1328

0.96" Inch I2C OLED Display White

Size: 0.96 Resolution: 128X64 Color: White Viewing angle: greater than 160 degrees Low power consumption: 0.04W during normal operation Support wide voltage: 3.3V-5V DC Working temperature: -30-80 degrees Volume: 27MM * 27MM * 4.1MM Driver IC: SSD1306 Communication: IIC, only two I / O ports Backlight: OLED self light, no backlight

Reference: RBD-1218

Nextion NX8048T050 - 5.0" LCD TFT HMI Touch Display

Nextion is a seamless Human Machine Interface (HMI) solution that provides a control and visualization interface between a human and a process, machine, application or appliance. Nextion is mainly applied to Internet of thing (IoT) or consumer electronics field.

Reference: RBD-353

0.96" Inch I2C OLED Display Yellow

Size: 0.96 Resolution: 128X64 Color: Blue, Yellow Viewing angle: greater than 160 degrees Low power consumption: 0.04W during normal operation Support wide voltage: 3.3V-5V DC Working temperature: -30-80 degrees Volume: 27MM * 27MM * 4.1MM Driver IC: SSD1306 Communication: IIC, only two I / O ports Backlight: OLED self light, no backlight

Reference: 1735

Waveshare 10.1inch Capacitive Touch Screen LCD (B) with Case 1280×800 HDMI-Compatible IPS display

Original Waveshare The LCD and Control BoardIPS screen,1280x800 high resolutionCapacitive touch control supports up to ten-points touchWhen works with Raspberry Pi, supports Raspbian, Ubuntu, single touch, and driver freeWhen working as a computer monitor, supports Windows 10/8.1/8/7, ten-points touch, and driver freeSupports Banana Pi, Banana Pro, comes...

Reference: RBD-340

Brand: Waveshare

5inch HDMI Touch Screen (B) + Bicolor Case (Original Waveshare)

5inch HDMI LCD with TouchScreen (B) + Bicolor Case Installation Method & Driver System Support: Raspberry Pi /  Windows / Support any HDMI System with Touch The LCD 800×480 high resolution Resistive touch control Supports Raspberry Pi Supports Banana Pi / Banana Pro, comes with Lubuntu, Raspbian images Supports BB Black, comes with Angstrom image...

Reference: RBD-699

1.8" inch TFT LCD Display module ST7735S 128x160

1.8-inch color screen,support 65K color display,display rich colors 128X160 resolution, clear display Using the SPI serial bus, it only takes a few IOs to illuminate the display With SD card slot for convenient function expansion Provide underlying libraries and rich sample programs for Arduino, C51, and STM32 platforms Military-grade process standards,...

Reference: RBD-1417

MAX7219 Dot Led Matrix LED Display Module

SMD-MAX7219-MODULE A single module can drive an 8 * 8 common cathode lattice Module Operating voltage: 5V. Module with input and output interfaces Supports multiple modules cascade Led color: Red 8x8 Dot Matrix Module - Cascadable, MAX7219

Reference: RBD-1164

LCD Display 16X2 with Header

This LCD comes with male header already soldered. So you don't have to worry about soldering it. You can straight connect it with the breadboard.

Reference: RBD-1642

LCD 16x2 Blue Backlight

This is a basic 16 character by 2 line display with a blue background .

Reference: RBD-1540

EL Wire-Blue 3m With Pocket Inverter

EL wire is a thin copper wire coated in a phosphor that glows a 360 degree unbroken light when an alternating current is applied to it. It is bendable as a thin neon tube which makes it ideal for flexible decoration. It is great for car decoration, parties, camping and so on.

Reference: RBD-1167

Raspberry Pi 7inch HDMI Touchscreen LCD with Case

7inch HDMI LCD (C), 1024×600, IPS, with Bicolor case Original Waveshare Included:  7inch HDMI LCD (C) x 1 HDMI cable x 1 HDMI to Micro HDMI Adapter x 1 USB type A plug to micro B plug cable x 1 RPi screws pack (4pcs) x 1 Bicolor Case for 7inch LCD x 1 Screws Pack x 1 Quick start sheet x1

Reference: RBD-1306

8*8 LED matrix module common anode of LED matrix

Dot Matrix Led Display

Reference: RBD-433

I2C LCD Adapter Module

As the pin resources of Arduino controller is limited, your project may be not able to use normal LCD shield after connected with a certain quantity of sensors or SD card. However, with this I2C interface LCD module, you will be able to realize data display via only 2 wires. If you already has I2C devices in your project, this LCD module actually cost no...

Reference: RBD-1634

OLED Display Module 0.91 Inch

I2C OLED Display Module 0.91 Inch I2C OLED DC 3.3V~5V Display Module

Reference: RBD-1332

I2C Graphic 128x64 LCD Adapter

This is I2C adapter for Graphic LCD 128x64, very suitable for interactive work with Arduino, Raspberry. In this adapter used driver MCP23017. For instruction and libraries you can find information here: www.gammon.com.au/forum/?id=10940 For change I2C adress you can folow infromation on bottom side of board.  Control of backlight: Normal backlight use...

Reference: RBD-401

LCD Module 8x2 Characters Display

BLUE COLORThis little 8-character, 2-line parallel liquid crystal display is a generic equivalent of the Optrex DMC-50448N-AAE-AD LCD. It is incorporated into our Orangutan SV-328 robot controllers, some versions of our  A-Star 32U4 Prime microcontroller boards,  

Reference: RBD-274

Brand: Waveshare

Raspberry Pi 5inch Resistive Touch HDMI LCD

5 inch Resistive Touch Screen LCD, HDMI interface, Designed for Raspberry Pi Installation Instruction: http://www.waveshare.com/wiki/5inch_HDMI_LCD Raspbian Image for 5 inch HDMI Diplay with Touch :  Raspbian 5 inch HDMI with Touch Download Link    

Reference: RBD-1109

10 Digit LED Bar Graph Display

These 10 segment bar graph LEDs have many uses. With a compact footprint, simple hookup, they are easy for prototyping or finished products. Essentially, they are 10 individual blue LEDs housed together, each with an individual anode and cathode connection. We also carry these in red, and green. Note: The pinout on these bar graphs may vary from what is...

Reference: RBD-924

TM1637 LED Display Module for Arduino

4 Bits 0.36Inch Clock RED Anode Digital Tube Four Serial Driver Board Control Interface: A total of four pins (GND, VCC, DIO, CLK), GND to ground, VCC is the power supply, DIO of data input and output pin, CLK is the clock signal pin;

Reference: RBD-339

Brand: Waveshare

3.5inch Resistive Touch Display (B) for Raspberry Pi

3.5inch Resistive Touch Display (B) for Raspberry Pi, 480×320, IPS Screen, SPI

Reference: RBD-305

3.5 inch RPi Display

320×480 resolution Resistive touch control Supports any revision of Raspberry Pi (directly-pluggable) Compatible with Raspberry Pi A, B, A+, B+, 2B, 3B, 3B+,4B versions Drivers provided (works with your own Raspbian/Ubuntu directly) Size perfectly fits the Pi High quality immersion gold surface plating Supports Raspbian system, ubuntu system ,kali Linux...

Reference: RBD-1539

EL Wire-Red 3m With Pocket Inverter

EL wire is a thin copper wire coated in a phosphor that glows a 360 degree unbroken light when an alternating current is applied to it. It is bendable as a thin neon tube which makes it ideal for flexible decoration. It is great for car decoration, parties, camping and so on.

Reference: RBD-234

Brand: SparkFun Electronics

LCD Cape - pcDuino V3 (1024x600 7" LVDS)

Description: This is a 7" LVDS LCD Cape for the pcDuino V3  with a 1024x600 screen resolution and capacitive touch from  LinkSprite. This massive screen is a great addition for the  pcDuino V3 that compliments its extreme versatility as a mini  PC development platform. 

Reference: RBD-1538

EL Wire-Green 3m With Pocket Inverter

EL wire is a thin copper wire coated in a phosphor that glows a 360 degree unbroken light when an alternating current is applied to it. It is bendable as a thin neon tube which makes it ideal for flexible decoration. It is great for car decoration, parties, camping and so on.

Reference: RBD-258

Brand: SparkFun Electronics

SparkFun Micro OLED Breakout

SparkFun Micro OLED Breakout

Reference: RBD-661

Standard LCD 16x2

Standard LCD 16x2