How to Place an Order
Store Pick Up
Request for Quotation/ International Sourcing
Order Status
Reference: 984
Heat Shrink Tubing 2:1, Eventronic Electrical Wire Cable Wrap Assortment Electric Insulation Heat Shrink Tube Kit (1 pcs) Please Choose Size Below
Reference: 1354
Length: 8.5 inches (Medium) Material: Copper Plated.EachPin Spacing: 2.54mm.Color: Colorfulcompatible with 2.54mm mil spacing pin headers.It can be used for PCB project, pc motherboard, etc.Allow you to plug and unplug easily for prototyping.Package Contents: 1 x Jumper Wire You will get only one pcs.
Reference: 245
Choose your desire Resistor value from below:
Reference: 31
3 Types Available 1. Male to Male 2. Male to Female 3. Female-Female
Reference: 94
Arduino UNO in Bangladesh The Arduino Uno is a microcontroller board based on the ATmega328 (datasheet). It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz ceramic resonator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller.
Use this simple IR receiver for infrared remote control of your next project. With low power consumption and an easy to use package, it mates well with embedded electronics and can be used with common IR remotes.
The TSOP382 is a miniaturized receiver for infrared remote control systems. A PIN diode and a preamplifier are assembled on a lead frame while the epoxy package acts as an IR filter. The demodulated output signal can be directly decoded by a microprocessor. The TSOP382 is compatible with all common IR remote control data formats.
Store Pickup Available!
Free Ship Over 5000 BDT
Quality Product
No Warranty
No Replacement
Use this simple IR receiver for infrared remote control of your next project. With low power consumption and an easy to use package, it mates well with embedded electronics and can be used with common IR remotes.
The TSOP382 is a miniaturized receiver for infrared remote control systems. A PIN diode and a preamplifier are assembled on a lead frame while the epoxy package acts as an IR filter. The demodulated output signal can be directly decoded by a microprocessor. The TSOP382 is compatible with all common IR remote control data formats.
Reference: 344
Weighing Sensor 24 Bit HX711 Dual-Channel Precision A/D Module Pressure Sensor. This module uses 24 high precision A/D converter chip HX711. It is a specially designed for the high precision electronic scale design, with two analog input channel, the internal integration of 128 times the programmable gain amplifier.
Reference: 312
Arduino TTP229 16 Channel Digital Capacitive Switch Touch Sensor Module GM
Reference: 321
PT100 Platinum Resister Temperature Sensor Waterproof Probe -20℃ ~ 450℃
Reference: 424
Features: Precision Relative Humidity Sensor± 3% RH (max), 0–80% RHHigh Accuracy Temperature Sensor±0.4 °C (max), –10 to 85 °C0 to 100% RH operating rangeUp to –40 to +125 °C operating rangeWide operating voltage (1.9 to 3.6 V)
Reference: 355
Description:Working voltage: 4.5V to 5.5 V.Transmit tube pressure drop: Vf = 1.6 VTransmit tube current: 20 mASignal output: A, B two way; The TTL levelDistinguish precision: 0.01 mmMeasurement frequency, 100 KHZEncoder diameter: 24 mmEncoder type D hole diameter: 4 mmThe encoder resolution: 20 line
Reference: 431
VOC gas sensors are used to detect formaldehyde, toluene, benzene, etc., is a type of semiconductor sensors, it is widely used in ventilation, ventilation fans, air filters, hood, hood and other equipment. With high sensitivity and stability, able to detect more than 0.1ppm gas, air suitable for detecting a variety of volatile organic components...
Reference: 1366
DT8380FC Infrared Thermometer Item no.: DT8380FC Temperature Range: -50~380°C/-58~716°F Measuring Accuracy: ±2% or 2C Distance Ratio: 12:1 Product description: DT8380FC Infrared Thermometer
Reference: 915
Overview RDM6300 125KHz cardreader mini-module is designed for reading code from 125KHz card compatible read-only tags and read/write card . It can be applied in office/home security, personal identification, access control, anti-forgery, interactive toy and production control systems etc.
Reference: 554
The VL53L0 uses ST’s FlightSense technology to precisely measure how long it takes for emitted pulses of infrared laser light to reach the nearest object and be reflected back to a detector, so it can be considered a tiny, self-contained lidar system. This time-of-flight (TOF) measurement enables it to accurately determine the absolute distance to a target
Reference: 693
Infrared Line Track Tracker Follower Sensor
Reference: 393
Specification: Brand new Color: as picture shows Size: approx. 34 x 26 x 32mm (L x W x H) Quantity: 1pc PS2 joystick joysticks standard interface module electronic building blocks and 2.54mm pin interface leads
Reference: 351
Specifications: This card is compatible with NFC capable phones and tablets, it is Smart Card Tags. Frequency: 13.56 MHz 1K byte EEPROM memory (768 FREE BYTES availability) Size: 85mm x 54mm x 0.9mm Material: PVC, Waterproof Write endurance 100,000 cycle Reading distance is 0 - 10cm (Reading distance depends on readers, not the cards)
Reference: 426
GUVA-S12SD UV Detection Sensor Module Light Sensor 240nm-370nm For Arduino
Reference: 416
The TTP229 is capacitive sensing design specifically for touch pad controls. The device has a built in regulator for the touch sensor. Stable sensing method can cover diversity conditions. Interface control panel links through non-conductive dielectric material. The main application is focused at replacing of the mechanical switch or button.
Reference: 414
This is a pre-wired and waterproofed version of the DS18B20 sensor. Handy for when you need to measure something far away, or in wet conditions. While the sensor is good up to 125°C the cable is jacketed in PVC so we suggest keeping it under 100°C. Because they are digital, you don't get any signal degradation even over long distances!
Reference: 1178
Superbright Ultra Violet LED UV Lamp 5mm 2500mcd **Damage from UV exposure is cumulative and increases your skin cancer risk over time. So be careful when you use it.
Reference: 352
Description knock sensor module and a digital interface, built-in LED build a simple circuit to produce percussion flasher.Interface comes with digital LED, will knock sensor connected digital 3 interface, when percussion sensor senses measure to percussive signals, LED flashing light.
Reference: 555
Product Description 1. Current sensor chip: ACS712ELC-30A. 2. Pin 5V power supply, on-board power light. 3. The module can be measured plus or minus 30A current, Corresponding analog output of 66 mV / A. 4. No test current through, the output voltage is VCC / 2. 5. PCB size: 31 (mm) x13 (mm).
Reference: 288
GY-801 Multi-Sensor Board - 3 Axis Gyro -3 Axis Accelerometer - 3 Axis Magnetometer, Barometer, Thermometer
Reference: 672
MQ-3 Alcohol Ethanol Sensor Breath Gas Detector Ethanol Detection For Arduino
Reference: 1205
Slamtec RPLIDAR A1 2D 360 Degree 12 Meters Scanning Radius LIDAR Sensor Scanner for Bstacle Avoidance and Navigation of Robot Features: Measures distance data in more than 8000 times/s 360 Degree Omnidirectional Laser Range Scanning 8000 times sample rate,the highest in the current economical LIDAR industry OPTMAG Original Design,prolong the life-span...
Reference: 307
STOCK OUT MLX90614 Contactless Temperature Sensor Module For Arduino Compatible Application: Thermal Imaging Camera, Wireless Temparature Measure. Easy to integrateFactory calibrated in wide temperature range:-40…+125°C for sensor temperature and-70…+380°C for object temperature.
Reference: 1201
The TFMini is a ToF (Time of Flight) LiDAR sensor capable of measuring the distance to an object as close as 30 centimeters and as far as 12 meters! As with all LiDAR sensors, your effective detection distance will vary depending on lighting conditions and the reflectivity of your target object, but what makes this sensor special is its size. Measuring...
Reference: 428
Description: This is RGB and Gesture Sensor, a small breakout board with a built in APDS-9960 sensor that offers ambient light and color measuring, proximity detection, and touchless gesture sensing. This is, in fact, the same sensor that the Samsung Galaxy S5 uses and is probably one of the best gesture sensors on the market for the price.
Reference: 386
Precision Real Time Clock Module DS3231 AT24C32 I2C With Battery
Reference: 156
TCS230 TCS3200 Color Sensor Recognition Module
Reference: 1197
The TSOP38236 is a miniaturized receiver for infrared remote control systems. A PIN diode and a preamplifier are assembled on a lead frame, the epoxy package acts as an IR filter. The demodulated output signal can be directly decoded by a microprocessor.
Reference: 658
FTDI USB to TTL Serial Converter Adapter FT232RL
Reference: 386
Precision Real Time Clock Module DS3231 AT24C32 I2C With Battery
Use this simple IR receiver for infrared remote control of your next project. With low power consumption and an easy to use package, it mates well with embedded electronics and can be used with common IR remotes.
The TSOP382 is a miniaturized receiver for infrared remote control systems. A PIN diode and a preamplifier are assembled on a lead frame while the epoxy package acts as an IR filter. The demodulated output signal can be directly decoded by a microprocessor. The TSOP382 is compatible with all common IR remote control data formats.
