Robotic Claw - MKII With Metal Servo

Robotic Claw - MKII DesCription: This robotic claw is a step up from the classic. The MKII takes everything you loved about the standard robot claw from DAGU and makes some significant improvements! 

Just like the classic claw, they are made from metal and are pretty heavy-duty, but the MKII also features brass sleeves in the joints which make them more rigid and less likely to come loose. The claw opens to about 2" and depending on the servo motor used, it can pick up some relatively heavy objects. The new spring-loaded clutch helps protect your servo gears from damage and also increases the gearing to 2:1, allowing the servo to act over its entire range and provide more gripping power!

These also have a mounting plate on the bottom which accepts standard spacing found on servo mounts (the extra bits that come with our servo motors). These do not come with a servo motor, so check below, the 'medium servo' is the one that works well.

Servo Description: Here is a simple, low-cost, high quality servo for all your mechatronic needs. This servo is able to take in 6 volts and deliver 44.4 oz-in. of maximum torque at 0.18 sec/60°

This is a small servo with a standard 3 pin power and control cable, and all hardware listed below.

Servo Features:

• Voltage: 4.8-6.0 Volts
• Torque: 38.8/44.4 oz-in. (4.8/6.0V)
• Speed: 0.20/0.18 sec/60° (4.8/6.0V)
• Rotation: 180°
• Dual Ball Bearing
• Metal Gears 

Servo Includes:

• 1x S05NF Metal Gear Servo
• 1x Double Arm Horn
• 1x Circle Horn
• 2x 3x22mm Phillips Screw
• 2x 3x2.5mm Phillips Screw
• 3x 2x9mm Phillips Screw
• 4x 2mm Nut

Servo Dimensions:

• 28.8 x 13.8 x 30.2mm
• Wire Length: 180mm
• Weight: 20g

Robotic Claw - MKii Documents:

• Dimensional Drawing
• Assembly Diagram
• Assembly Instructions (Large File)

Servo Documents:

• Datasheet