- Raspberry Pi
- Mini Computer/ PC
- 3D Printer
- Internet of things (IoT)
- Arduino Shield
- Robotics Parts
- Home Automation
- Industrial Shield
- Industrial Component
- Motor Driver
- Communication Module
- Robot Platform Chassis
- Power Module & Adapter
- PLC Cable
- Tools & Accessories
- Thermal Printer
- Solar Panel
- Battery & Charger
- Retired Products
Length: 8.5 inches (Medium) Material: Copper Plated.EachPin Spacing: 2.54mm.Color: Colorfulcompatible with 2.54mm mil spacing pin headers.It can be used for PCB project, pc motherboard, etc.Allow you to plug and unplug easily for prototyping.Package Contents: 1 x Jumper Wire You will get only one pcs.
Arduino UNO in Bangladesh The Arduino Uno is a microcontroller board based on the ATmega328 (datasheet). It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz ceramic resonator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller.
LCD Cape - pcDuino V3 (1024x600 7" LVDS)
Description: This is a 7" LVDS LCD Cape for the pcDuino V3
with a 1024x600 screen resolution and capacitive touch from
LinkSprite. This massive screen is a great addition for the
pcDuino V3 that compliments its extreme versatility as a mini
PC development platform.
Store Pickup Available!
Free Ship Over 5000 BDT
Description: This is a 7" LVDS LCD Cape for the pcDuino V3 with a
1024x600 screen resolution and capacitive touch from LinkSprite. This
massive screen is a great addition for the pcDuino V3 that compliments
its extreme versatility as a mini PC development platform. The LCD cape
is extremely easy to install, simply plug it into the LVDS (Low-Voltage
Differential Signaling) port on the pcDuino V3, load the touch driver
kernel, and you’ll have this screen up in no time.
This LVDS LCD removes the necessity of a bulky full sized monitor to
operate the pcDuino V3 by attaching to individual I2C pins on the dev
board. Everything that you need to set this LCD up is included, including
the LCD itself, a ribbon calbe to attach to the LVDS port, and 10 male to
female jumper wires (connected) to attach to the pcDuino’s headers.
Note: This LCD does require a touch driver kernel that supports LVDS
which can be found in the Documents section below.
- 1x LVDS LCD Cape
- 1x Ribbon Cable
- 10x M/F Jumper Wire
(Retired) Raspberry Pi 3 Model B+ (Made in UK) Broadcom BCM2837B0, Cortex-A53 (ARMv8) 64-bit SoC @ 1.4GHz 1GB LPDDR2 SDRAM 2.4GHz and 5GHz IEEE 802.11.b/g/n/ac wireless LAN, Bluetooth 4.2, BLE Gigabit Ethernet over USB 2.0 (maximum throughput 300 Mbps) Extended 40-pin GPIO header Full-size HDMI 4 USB 2.0 ports