Reference: RBD-0335

E-TECH SimonK 30A Brushless ESC Speed Controller

Features: Simonk Programe, Perfect drive Low voltage, over heat protection, with power on self detection function MCU and BEC with independant regulator, high anti-interference ability Throttle stroke adjustable, compatiable with different receivers, good low speed performance

Reference: RBD-0379

TS832 RC832 Boscam 5.8G 32CH 250mW FPV Transmitter Receiver 7.4-16V

1 review

TS832 RC832 5.8G 32CH 250mW FPV Transmitter Receiver 7.4-16V

Reference: RBD-2065

JQ6500 HW-896 V1.2 Voice Sound MP3 Player Module

Play standard mono or stereo MP3 files Control with buttons Serial communications protocol (JQ6500 Arduino Library available). Power supply 4.2V Speaker power 4 ohms / 3 watts

Reference: RBD-0380

Eachine VR D2 40CH 5 Inches 800 x 480 Raceband 5.8G Diversity FPV Goggles with DVR Lens Adjustable

1 review

Eachine VR D2 40CH 5 Inches 800 x 480 Raceband 5.8G Diversity FPV Goggles with DVR Lens Adjustable

Reference: RBD-0351

MIFARE Classic 1K RFID NFC Smart Card 13.56MHz Printable

39 reviews

Contactless transmission of data and supply energy (no battery needed) Operating distance: Up to 100mm (depending on antenna geometry) RoboticsBD Operating frequency: 13.56MHz Data transfer: 106 kbit/s Data integrity: 16 Bit CRC, parity, bit coding bit counting Anticollision Typical ticketing transaction: <100 ms ( including backup management)...

Reference: RBD-0381

APM 2.6 Pixhawk Power Module V1.0

5 reviews

Operating Voltage:6~28 VDC Max Input Voltage:28 V DC Max Current Sensing: 90 A Connecting Type:XT-60 RoboticsBD

Reference: RBD-0437

600TVL 1/4 1.8mm Lens CMOS 170 Degree Wide Angle CCD Mini FPV Camera NTSC

3 reviews

Power supply range: 3.7-5V 100mA Resolution: 1280 x  960 Resolution: 600TVL Illumination: 0.5LUX Format: PAL / NTSC Audio Lens: Wide-angle 1.8mm (170º) Image sensor:1/4 CMOS image sensor Sensitive area: 3.5964mm x 2.7084mm Size of the lens: M10

Reference: RBD-2372

RFID Reader Module 125KHz TK4100 RF UART IO Output Board For Access Control

This product is an ID card decoding module. After sensing the ID card, it will actively decode and output the 10-digit card number. It also has an output port that can output high and low levels, which can meet the requirements of general ID cards, such as reading, deleting, and registering. Card operation!

Reference: RBD-1021

PAM8406 5Wx2 Class D Digital Stereo Audio Power Amplifier Module Board

3 reviews

Operating voltage: 2.5V-5.5V, recommended 5V Speaker Load: 2-8 Ohms Input and Output Connectors: Pins on 0.2" centers Size: 24 x 23 x 105 mm (L x W x H) Net weight: 3g

Reference: RBD-2294

JQ6500 V2.1 MP3 Player Module

JQ6500 MP3 Voice sound module can play stereo MP3 files or standard mono audio files. The module has two different modes to operate in; serial communication mode (connecting to a microcontroller) or AD button control mode (module can be controlled with switches).

Reference: RBD-2307

Stereo Enclosed Speaker 3W 8Ω

1 review

This speaker is a great addition to any audio project where you need 8 ohm impedance and 3W or less of power. We particularly like this speaker as it is small and enclosed for good audio volume and quality. It has a handy JST 2PH input cable to add audio to your displays and other projects (this connector is part of the JST-PH series which is ~2.0mm...

Reference: RBD-2318

Sound Output Module Speaker Module Microphone Sensor Module Sound Sensor for Arduino

The Speaker module is composed of a power amplifier and a loudspeaker. Sound size can be adjusted by the potentiometer on the circuit board. Enter different frequencies, the speakers produce different tones. Can be carried out by for Arduino encoding and DIY their music box!Product data interfaceusing anti plug,the two sides of the interface are...

Reference: RBD-0826

PolyMax 3.5mm Gold Connectors (1pair)

13 reviews

PolyMax 3.5mm Gold Connectors 3.5mm sprung gold connectors  handle the large current, 50A+ systems. perfect for 3500mAh or larger capacity batteries 

Reference: RBD-2541

Brand: DFRobot

Gravity: Voice Recorder Module

This is the latest voice recorder module with integrated record and play functions. Easily record your voice by pressing the record button, speaking and then releasing the button when finished. The module is able to playback 10 seconds in total. Connect an 8Ω 3W speaker or an external active speaker for voice output. The module also has a 3 pin digital...

Reference: RBD-2691

Through-Hole Speaker 15mm diameter - 2kHz range

Compact 15mm speaker for integrating sound into space-constrained projects. 2kHz frequency range suitable for basic audio applications. Through-hole mounting for easy integration with circuit boards. Handles up to 0.5W of power for moderate sound output.

Reference: RBD-0214

FPV Camera Color 480p

FPV Camera Color 480p This Camera Can be used with this Boscam FPV 5.8Ghz AV Transmitter and Receiver for FPV Purpose

Reference: RBD-2694

4cm Thin Speaker - 8 Ohm 0.5W

Incredibly thin (just over 4mm) 4cm speaker for adding sound to projects with severe space constraints. 8Ω impedance and 0.5W power handling for compatibility with low-power audio circuits. Ideal for applications like portable devices, greeting cards, or space-limited enclosures.

Reference: RBD-2718

PAM 8610 Digital Stereo Class-D Amplifier Board 2x15W Output

Dual-Channel Stereo Output Run-on 7V to 15V power Supply 32 Steps DC volume control has a +32dB to -75dB range. 40 pin QFN 6 x 6 mm package. Much higher efficiency in terms of cost and performance than competitors’ ICs

Reference: RBD-2724

MAX4466 Electret Microphone Adjustable Amplifier Module

The MAX4466 Electret Microphone Module is a convenient and sensitive audio sensor solution designed for capturing sound waves and converting them into electrical signals. This module incorporates the MAX4466 electret condenser microphone and an integrated amplifier circuit, making it well-suited for applications requiring clear and amplified audio capture.

Reference: RBD-2747

Mini Speaker - PC Mount 12mm 2.048kHz

This is a small 12mm round speaker that operates around the audible 2kHz range. You can use these speakers to create simple music or user interfaces. This is not a true piezoelectric speaker but behaves similarly. Instead of a piezoelectric crystal that vibrates with an electric current, this tiny speaker uses an electromagnet to drive a thin metal sheet....

Reference: RBD-2758

MAX9814 Microphone Amplifier Module

With this module you can easily measure sound with an analog pin on your Arduino or other microcontroller. The module has an automatic gain/amplification (ACG) of the microphone: The module amplifies sounds with a low volume more, and sounds with a higher volume less.

Reference: RBD-0946

Generic SP Racing F3 EVO Brushed V2.0

3 reviews

Supported Receiver Input Signal: PPM, SBUS, DSM Support PPM, SBUS, DSM receiver input signal Battery voltage detection and buzzer interface Large current NMOS transistors, operating current can reach 10A or higher Use STM32F303CCT6 + MPU6500, advanced hardware platform F3 for higher flight stability

Reference: RBD-0940

JST connectors (male+female) Pair 95mm

5 reviews

Good Quality Type: Male-Female Plated Connectors Length: 10 cm Color: Red and Black

Reference: RBD-0403

Radiolink AT9S Pro 10/12 Channels 2.4GHz RC Transmitter and Receiver Mode 2

AT9S Pro 10CH/12CH           Optional DSSS&FHSS/CRSF Protocols Ideal for Flying Virtually any Type of Aircraft     Compatible with R12DS, R12DSM, R9DS, R6DS, R6DSM

Reference: RBD-0172

FlySky FS-T6 2.4ghz 6 Channel TX & RX

FlySky FS-T6 2.4ghz Digital Proportional 6 Channel Transmitter ＆ Receiver System FlySky Introduces its newest 6 channel 2.4GHz system, The FS-T6. After years of success with the CT6B, FlySky presents the new FS-T6 with loads of cool and convenient features making the operation of this transmitter simple and instinctive.

Reference: RBD-0140

QuadCopter Fiber Glass Frame X600 V3

QuadCopter Fiber Glass Frame X600 V3

Reference: RBD-1569

8045 Carbon Nylon CW/CCW Propeller Pair

4 reviews

Length: 8″. Pitch: 4.5″. Weight: 20 gm. Shaft Diameter: 9.5mm. Total Length: 8 inch / 200 mm. It comes with a set of plastic reducers (3,3.17,4,5,6,8 mm).

Reference: RBD-2506

SP Racing F3 MOF3 V1 Cleanflight Flight Controller Kit

The SF Racing F3 flight controller is designed to provide high performance flight experience for the hobbyists. With verified sensor algorithm, it provides incomparable I/O capabilities. The SF Racing F3 runs a next-generation 32-bit STM32F303CCT6 processor, an MPU6500 accelerometer and a gyroscope sensor, all high integrated on a lightweight PCB to...

Reference: RBD-2507

GY-US42 V2 i2c Pixhawk APM Flight Control Ultrasonic Distance Measurement Module

Reference: RBD-2563

Flywing 30A 2s-3s Brushless ESC 1000KV-1400KV 5V/2A for RC Airplane

Introducing the FLYWING Brushless ESC, a high-performance electronic speed controller designed for RC airplane models and hobby planes. This ESC offers reliable and top-quality components to enhance the overall performance of your RC aircraft.

Reference: RBD-2774

FPV Head Tracker Dual Axis Servo Gimbal Bracket

Enhance your DIY RC robot or FPV setup with the FPV Head Tracker Dual Axis Servo Gimbal Bracket. This dual-axis servo gimbal bracket is designed to securely hold your camera in place, allowing for stable and precise positioning during operation. Crafted from lightweight aluminum alloy, this bracket ensures durability without adding unnecessary weight to...

Reference: RBD-2893

ESC Power Distribution Board Soldered T Plug & 3.5mm Banana Bullet Connectors

Compatible with MK KK flight control installment pitch of holes Compatible with MK KK flight control system Can connect 1-8 ESC. This has an T plug to connect a battery. This Distribution board has 8 number of the channel to connect different ESCs with 3.5mm Banana Bullet Connectors.