Reference: RBD-0218

High Torque Gear Motor 12V, 50 RPM

High Torque Gear Motor 12V, 50 RPM Volt: DC 12V RPM: 50 Torque 13KG/CM

Reference: RBD-0368

Force Sensitive Resistor 0.5"

2 reviews

Thickness: 0.4mm Trigger Force: 20g, triggered (default resistance<200kΩ)  Pressure Measuring Range: 20g~6kg Static Pressure & Dynamic Pressure Measurement (within the frequency of 10Hz) Initial Resistance: >10MΩ Activation Time: <0.01S Operating Temperature: -40°C~+85°C  Lifespan: >1million times Hysteresis: +10%，(RF+ -RF-)/FR+，1000g...

Reference: RBD-2352

HLK-LD2410B with BLE 24GHz mmWave Intelligent Switch Human Presence Sensing Radar Module

LD2410B is a high-sensitivity 24GHz human presence status sensing module developed by Hilink Electronics. Its working principle is to use FMCW frequency-modulated continuous wave to detect human targets in the set space. Combined with radar signal processing and accurate human body sensing algorithms, it realizes high-sensitivity human presence status...

Reference: RBD-0426

GUVA-S12SD UV Detection Sensor Module

3 reviews

Power supply voltage of 2.5 V ~ 5 V Low power consumption Wide detection range: 240 nm to 370 nm Wide Angle: 130 degrees Schottky type photosensitive diode Good linear response High sensitivity

Reference: RBD-0391

AD8232 ECG Measurement Module Kit

19 reviews

Designed to extract, amplify, and filter small biopotential signals. Leads-Off Detection. Shutdown Pin. LED Indicator. Analog Output. 3.5 mm Jack for Biomedical Pad Connection. RoboticsBD

Reference: RBD-0982

Digital Barometric Pressure Sensor Module 0-40kPa

2 reviews

Model: HX710B Data Output Rate:10 SPS / 80SPS Max. Operating Current (mA):1.5 IC Package:16 Pin SOP

Reference: RBD-0554

GY-VL53L0XV2V VL53L0X Time-of-Flight Distance Sensor Breakout Module

3 reviews

VL53L0X 3-in-1 ranging and gesture detection sensor Regulator: 5 to 2.8V range input voltage (output voltage: 2.8V) VL53L0X signal interface level shifter Serial Port PWM Output True distance measurement independent of target size and reflectance Breakout board, easy to integrate into the customer device Allows basic gesture recognition use case. RoboticsBD

Reference: RBD-2228

CJMCU-9833 AD9833BRMZ Programmable Sine Triangular Square Waveform Generator Module

2 reviews

Working voltage: 2.3V-5.5V. Working temperature range: -40 ~ + 105. Onboard 25MHZ (accuracy of 50ppm) active crystal. On-board high-speed amplifiers

Reference: RBD-2488

W5100 Ethernet Network Module for Arduino

1 review

Support Hardwired TCP/IP Protocols: TCP, UDP, ICMP, IPv4 ARP, IGMP, PPPoE, Ethernet 10BaseT/100BaseTX Ethernet PHY embedded Auto-Negotiation (Full-duplex and half duplex) Support Auto MDI/MDIX Simultaneously Supports to 4 independent sockets 0.18 µm CMOS technology 3.3V operation with 5V I/O signal tolerance Provide Serial Peripheral Interface (SPI MODE...

Reference: RBD-2147

GY-63 MS5611-01BA03 High Precision Pressure Sensor Height Sensor Module

1 review

The built-in 24bit AD converter. Immersion gold PCB, high quality, machine welding process to ensure quality. Power supply: 3 – 5V ( internal low dropout regulator ). Communication modes: Standard the IIC / SPI communication protocol.

Reference: RBD-0682

Arduino LilyPad 328 ATmega328P

2 reviews

Microcontroller: ATmega168 or ATmega328V Operating Voltage: 2.7-5.5 V Digital I/O Pins: 14 PWM Channels: 6 Analog Input Channels: 6 DC Current per I/O Pin: 40 mA Board will run from 2V to 5V. The latest version of the LilyPad supports automatic reset for even easier programming. The back side of the LilyPad is now completely flat! RoboticsBD

Reference: RBD-2039

DY-SV5W Audio Playback MP3 Module

Product Name:DY-SV5W Voice Playback Module Product Number:DY-SV5W Work Voltage:DC 5V Working Temperature range:-20℃~85℃ Working Humidity range:0%-95%RH Size :35*35*4.5mm

Reference: RBD-0195

Brand: RoboticsBD

25mW Infrared Line Laser Light

25mW Infrared Line Laser Light

Reference: RBD-0680

9 Degrees of Freedom Breakout- MPU9250

4 reviews

Acceleration, Gyroscope, and Magnetometer Power Supply: DC3.3V-5V Chip: MPU9250 Size: 22 mm x 17 mm. Gyro range : ± 250 500 1000 2000 ° / s Acceleration range: ± 2 ± 4 ± 8 ± 16g Magnetic field range: ± 4800uT 9 DOF modules. RoboticsBD

Reference: RBD-1210

OPT101P PHOTODIODE/AMPLIFIER

Single Supply:2.7-36V High Responsivity:0.45A/W(650nm) Bandwidth:14Khz

Reference: RBD-1700

Brand: Waveshare

ST-LINK V2 Mini- STM Programmers & Debuggers

Mini ST-LINK/V2  Small single board Extreme low cost solution  In-circuit debugger/programmer  STM8 STM32.

Reference: RBD-2372

RFID Reader Module 125KHz TK4100 RF UART IO Output Board For Access Control

This product is an ID card decoding module. After sensing the ID card, it will actively decode and output the 10-digit card number. It also has an output port that can output high and low levels, which can meet the requirements of general ID cards, such as reading, deleting, and registering. Card operation!

Reference: RBD-2515

5V Electromagnet - 5 Kg Holding Force - P25/20

Nominal Voltage: 5V DC Current Draw: 0.6 Amps at 5V Holding Force: 5 Kg / 11 lb Approximate Pickup Weight: 1 Kg / 2 lbEver wanted to feel like Magneto? Well, now you sort of can! Bring the ferromagnetic objects in the world under your control with an Electromagnet The simplest way to make an electromagnet is to get a solenoid, pass some current through...

Reference: RBD-2414

Yahboom 4 Channel Infrared Line Following Tracking Sensor Module

1 review

This tracking module adopts four tracking probes, and optimized spacing layout. The inner two probes can accurately identify the black line. The outer two probes can assist the inner probe to identify the black line and provide early warning. The car can recognize the 90°curved road and other difficult tracks. Knob-type adjustable resistors plus...

Reference: RBD-2518

Plastic Water Solenoid Valve - 12V - 1/2" Nominal

1/2" Nominal NPS Working Pressure: 0.02 Mpa - 0.8 Mpa Working Temperature: 1 ℃ - 75 ℃ Response time (open): ≤ 0.15 sec Response time (close): ≤ 0.3 sec Actuating voltage: 12VDC Actuating life: ≥ 50 million cycles

Reference: RBD-1599

Brand: Raspberry Pi Official

Raspberry Pi Pico

11 reviews

RP2040 microcontroller chip designed by Raspberry Pi Dual-core Arm Cortex M0+ processor, the flexible clock running up to 133 MHz 264KB of SRAM, and 2MB of onboard Flash memory 26 × multi-function GPIO pins 2 × SPI, 2 × I2C, 2 × UART, 3 × 12-bit ADC, 16 × controllable PWM channels Temperature sensor

Reference: RBD-2359

CC1101 500kbps Wireless Transceiver Module RF 433mhz SPI Interface SMA Antenna

This is a self-developed, small-size, 433 MHz DIP wireless module with a maximum tx power of 10mW based on CC1101 of Texas Instruments. Due to the adoption of the very mature CC1101 as the core chip, its stability has been unanimously praised by user. The module is mainly used in smart home, industrial, scientific research and medical, as well as...

Reference: RBD-2683

XH-M452 Temperature and Humidity Control Module with Digital Display

XH-M452 DC 12V LED Digital Thermostat Temperature Humidity Control Module The XH-M452 temperature and humidity control module is a versatile and precise solution for temperature and humidity regulation in various applications. With a power supply of DC 12V, this module offers reliable performance and accuracy. Key Specifications: Power supply: DC 12V...

Reference: RBD-0738

Raspberry Pi Camera 5MP

17 reviews

Resolution: 5 MP Interface Type: CSI(Camera Serial Interface) Dimensions: 25x23x8 (LxWxH) mm Supported Video Formats: 1080p @ 30fps, 720p @ 60fps and 640x480p 60/90 video Fully Compatible with Raspberry Pi 3 and 4 Model B Plug-n-Play camera for Raspberry Pi 3 and 4 Model B.

Reference: RBD-1678

Big Easy Driver - Stepper Motor Driver

2A phase 3D Printer Big Easy Driver board V1.2 A4988 stepper motor driver board Module

Reference: RBD-2163

6V 30:1 500RPM Micro Metal Gearmotor w/ Encoder

1 review

Built-in encoder Average output up to 420 pulses per revolution The brass faceplate has two mounting holes threaded Long D profile metal output shaft (0.354"/9.0 mm)

Reference: RBD-2562

Open Smart Long Range 433Mhz RF Wireless Transceiver Kit For Arduino

The kit includes one pair of transmitter and receiver modules for increasing the communication distance. And the frequency is 433MHz. It is very popular for remote control systems, such as wireless doorbell, remote control rolling gates, smart car, smart home, etc.

Reference: RBD-2346

HW-671 WCS1800 Hall Current Sensor Over-current Protection Module Detection

HW-671 WCS1800 Hall Current Sensor Over-current Protection Module Detection

Reference: RBD-0569

MPU9250 9-Axis Attitude Gyro Accelerator Magnetometer Sensor Module

Acceleration, Gyroscope, and Magnetometer Power Supply: DC3.3V-5V Chip: MPU9250 Size: 22 mm x 17 mm. Gyro range : ± 250 500 1000 2000 ° / s Acceleration range: ± 2 ± 4 ± 8 ± 16g Magnetic field range: ± 4800uT 9 DOF modules

Reference: RBD-2677

0.28" LED Digital Voltmeter Ammeter with 100V/10A Measurement With 100A Shunt

Operating on a 5V DC power supply with a current consumption of less than 60mA, this 0.28-inch Digital Voltmeter Ammeter is a versatile tool for measuring voltage and current. With a testing range of 0-100V for voltage and 1-100A for current, this meter offers precise measurements with easy readability, even in dim light conditions.

Reference: RBD-2130

9 Axis IMU L3GD20 LSM303D Module 9DOF Compass Acceleration Gyroscope Sensor Module

1 review

9DOF IMU module with compass, acceleration, and gyroscope sensors Captures nine different types of motion or orientation Measures 3-axis gyroscope, triaxial accelerometer, and triaxial magnetic field Power supply: 3-5V (internal low dropout regulator)

Reference: RBD-2347

TSL2591 High Dynamic Range Digital Light Sensor

TSL2591 Digital Light Sensor Breakout Module High Dynamic Range Lux IR Infrared Full Spectrum Diodes Detect 3.3V for Arduino