Ohm (Ω) 1/4w Resistors - Pack of 5

Brand: DFRobot

WiFi Shield V3 PCB Antenna Arduino Shield

WiFi Shield V3 PCB Antenna Arduino Shield INTRODUCTION DFRobot WiFi Shield, is part of our wireless family product. This WIFI Shield V3 supports AP + STA dual mode, and is extremely easy to connect to a home

5V LED Traffic Light Module

5V LED Traffic Light Module

UA741CN Operational Amplifier

Capacitor 25v 100uf

Brand: SparkFun Electronics

LIDAR-Lite v3

Features: Range: 0-40m Laser Emitter Accuracy: +/- 2.5cm at distances greater than 1m Power: 4.75–5V DC; 6V Max Current Consumption: 105ma idle; 130ma continuous Rep Rate: 1–500Hz Laser Wave Length/Peak Power: 905nm/1.3 watts Beam Divergence: 4 m Radian x 2 m Radian Optical Aperture: 12.5mm Interface: I2C or PWM

TTP229 8 Channel Digital Capacitive Switch Touch Sensor Module for Arduino

The TTP229 is capacitive sensing design specifically for touch pad controls. The device has a built in regulator for the touch sensor. Stable sensing method can cover diversity conditions. Interface control panel links through non-conductive dielectric material. The main application is focused at replacing of the mechanical switch or button.

18650 Li-ion Rechargeable Battery

18650 Li-ion Rechargeable Battery 3.7 Volt Rechargeable Lithium ION Re/Discharging Protection Circuit   It's a clone battery so the ampere couldn't be guaranteed.

Light Depending Resistor (LDR)

DC barrel jack

Push Button Switch

Obstacle Avoiding Robot Kit

BreadBoard

Solderless Large BreadboardA breadboard (or protoboard) is usually a construction base for prototyping of electronics. The term "breadboard" is commonly used to refer to a solderless breadboard (plugboard). Because the solderless breadboard for electronics does not require soldering, it is reusable. This makes it easy to use for creating temporary...

Reference: Sparkfun

RFID Reader ID-20LA (125 kHz)

Description: RFID (radio-frequency identification) is the wireless non-contact use of radio-frequency electromagnetic fields, for the purposes of identifying and tracking tags attached to objects. This is the ID-20LA, a very simple to use RFID reader module from ID Innovations. With a built in antenna, the only holdup is the 2mm pin spacing. Power the...

Mini Cooling Fan 40x40x10mm

4x4 Keypad - 16 Key - Matrix Membrane Type

4 x 4 Matrix Membrane Keypad Size: 7cm X 7.5cm 8 pin connector Adhesive mounting (sticker on the back side) Maximum Circuit Rating: 35VDC, 100mA Operation Temperature: 0 to +60 centigrade Humidity: 40 centigrade, 90%-95%, 240 hours Fexible Circuit Length: Approx. 3.3 inch / 83 mm

DC 12V Solenoid Electric Door Lock

Specifications:Voltage: DC12VCurrent: 0.6AEnergized forms: intermittentUnlocking time: 1SSize: 27x29x18mm (L * W * H)

MAX7219 Red Dot Matrix Module MCU Control Display Module DIY Kit For Arduino

Soldering is required

Digispark Kickstarter ATTINY85 Arduino General Micro USB Development Board

Digispark USB Development Board The Digispark is an Attiny85 based microcontroller development board similar to the Arduino line, only cheaper, smaller, and a bit less powerful. With a whole host of shields to extend its functionality and the ability to use the familiar Arduino IDE the Digispark is a great way to jump into electronics, or perfect for when...

Brand: DFRobot

Xbee Shield for Arduino (without Xbee)

Xbee Shield for Arduino (without Xbee) INTRODUCTION: The XBee Expansion Board is a compliant solution designed to meet low-cost, low-power wireless sensor networks with special needs.The module is easy to use, low power consumption, and the provision of critical data between devices reliable transmission.

3×4 Flexible Keypad

This keypad has 12 buttons, arranged in a 3×4 grid. It’s made of a thin, flexible membrane material  The keys are connected into a matrix, so you only need 7 microcontroller pins (3-columns and 4-rows) to connect the key pad.

LM358P Dual Operational Amplifiers Op-Amp DIP8

5V 1 Channel Solid State Relay (SSR)

10K Ohm Potentiometer

PL2303 USB to TTL Serial Converter (Windows 7 & 10 Compatible)

PL2303 USB to TTL Converter Windows 7 & 10 Compatible

5 mm Green LED (Pack of 5)

Tolsen Cordless Screwdriver (Set)

Cordless Screwdriver With Set

DS1302 Real Time Clock Module (DS1302Z clock chip,32.768KHZ crystal)

BC557 PNP Transistor

Brand: SparkFun Electronics

EasyVR Shield 3.0 - Voice Recognition Shield

Description:  Do you make time to talk to your Arduino? Maybe you should! The Easy VR Shield 3.0 is a voice recognition shield for Arduino boards integrating an EasyVR module. It includes all of the features of the EasyVR module in a shield form factor that simplifies connection to the Arduino main board and PC.

1k ohm Variable Pot Resistor 102

1K OHM 102 VARIABLE RESISTOR