Reference: RBD-1670

ESP8285 IR Infrared Transmitter Receiver Module WIFI Remote Control Switch

The smallest 802.11b/g/n Wi-Fi SoC module Uses low power 32bit CPU and compatible with the application processor Main frequency up to 160MHz Built-in 10Bit high precision ADC Support UART/GPIO/PWM/ADC interface Integrate Wi-Fi MAC/BB/RF/PA/LNA

Reference: RBD-0428

APDS-9930 RGB and Gesture Sensor

Operational Voltage: 3.3V. Ambient Light & RGB Color Sensing. Proximity Sensing. Gesture Detection. Operating Range: 4-8in (10-20cm). I2C Interface (I2C Address: 0x39). RoboticsBD

Reference: RBD-2131

S2 Mini V1.0.0 ESP32-S2 4MB FLASH 2MB PSRAM WIFI Development Board

ESP32-S2 based WIFI development board Features S2FN4R2 WIFI IC Equipped with 4MB FLASH and 2MB PSRAM Type-C USB connectivity 27 digital input/output pins with support for interrupt/pwm/I2C/single wire ADC, DAC, I2C, SPI, UART, USB OTG

Reference: RBD-0554

GY-VL53L0XV2V VL53L0X Time-of-Flight Distance Sensor Breakout Module

3 reviews

VL53L0X 3-in-1 ranging and gesture detection sensor Regulator: 5 to 2.8V range input voltage (output voltage: 2.8V) VL53L0X signal interface level shifter Serial Port PWM Output True distance measurement independent of target size and reflectance Breakout board, easy to integrate into the customer device Allows basic gesture recognition use case. RoboticsBD

Reference: RBD-0574

Honeywell HMC5983 Temperature Compensated Three-Axis Digital Compass

3-Axis Magnetoresistive Sensors and ASIC in a 3.0x3.0x0.9mm LCC Surface Mount Package Temperature Compensated Data Output and Temperature Output Automatic Offset Compensation. RoboticsBD

Reference: RBD-0622

RCWL-0516 Microwave Radar Sensor Module Human Body Induction Switch Module

6 reviews

Transmission signal processing control chip RCWL-9196 Wide operating voltage range 4.0V to 28.0V Penetrating detection capability, compared with the traditional infrared feeling PIR Adjustable Block time and distance Operating Current: 2.8mA (typical); 3mA (max) Detection Distance: 5-9m Transmitting Power: 20mW (typical); 30mW (max) RoboticsBD

Reference: RBD-0668

DS1302 Real Time Clock Module (DS1302Z clock chip,32.768KHZ crystal)

1 review

Crystal 32.768KHz, matching capacitance 6pF DS1302 8-pin SMD homemade chips Seconds, Minutes, Hours, Day of Month, Day of Week, and Year Operating temperature: 0 degree — 70 degree. RoboticsBD

Reference: RBD-2295

CC2530+CC2591 Zigbee Module Wireless Power Amplification Development Board with SMA Antenna

The CC2530 ZigBee series wireless module launched by BEE Iot Technology is a ZigBee RADIO frequency module developed based on TI's CC2530F256 chip. The module can complete ZigBee learning, project application, and industrial production, and can be widely used in the field of short-distance wireless communication networking. It can build powerful network...

Reference: RBD-2309

ESP8285 ESP-M2 Development Board

Add Internet to your next project with an adorable, bite-sized WiFi microcontroller, at a price you like! This module contains an ESP8285, which is an ESP8266 processor with 1MB of FLASH memory already built in. You can use it just like an ESP8266, it's the same processor and WiFi The ESP8266 processor from Espressif is an 80 MHz microcontroller with a...

Reference: RBD-2327

Brand: DFRobot

Self-powered Wireless Switch 433Mhz

In life, remote controllers can be seen everywhere, and most of them are inseparable from the battery. However, we often encounter problems when using the battery, for instance, it is troublesome to replace the battery, batteries are easy to corrode in a humid environment, or the waste batteries may cause serious environmental pollution. Do you know that...

Reference: RBD-2366

Espressif ESP32-S3-DevKitC-1-N8R8

The ESP32-S3-DevKitC-1 Version 1.0 is an entry-level development board equipped with ESP32-S3-WROOM-1, ESP32-S3-WROOM-1U, or ESP32-S3-WROOM-2, a general-purpose Wi-Fi + Bluetooth® LE MCU module that integrates complete Wi-Fi and Bluetooth LE functions. Most of the I/O pins on the module are broken out to the pin headers on both sides of this board for...

Reference: RBD-2371

Keyes Espressif ESP32-WROOM-32 Module Core Board

Our ESP32 core board is the perfect solution for anyone who wants an easy and convenient way to connect their peripherals. With our board, you'll have everything you need to develop and debug your own applications. The ESP-WROOM-32 module is a leading WiFi + Bluetooth solution that integrates with TSMC's low-power 40nm technology. This means that our...

Reference: RBD-2381

3D AI Face Recognition HLK-TX510 Test kit 3D Binocular Camera Live Detection Module

HLK-TX510 is a module developed based on artificial intelligence chip TX510, AI computing power 1.2T@8bit/9.6T@binary, supports mixed precision, can quickly detect faces, supports 3D living detection, 3D face recognition, infrared living detection, Visible light live detection, etc., can resist two-dimensional attacks such as photos and videos, and...

Reference: RBD-2386

Brand: Raspberry Pi Official

Raspberry Pi Pico W

1 review

The Raspberry Pi Pico W builds upon the great cost-for-performance metrics of the Pico and add WiFi to the board. The Pico W features the same attributes as the Raspberry Pi Pico and also incorporates an Infineon CYW43439 wireless chip. CYW43439 supports IEEE 802.11 b/g/n wireless LAN, and Bluetooth® 5.2. (6/30/2022: Only Wireless LAN is supported on the...

Reference: RBD-0683

Water Level Sensor Depth of Detection Water Sensor for Arduino

8 reviews

Operating voltage: DC3-5V Operating current: less than 20mA Sensor Type: Analog Detection Area: 40mmx16mm Operating temperature: 10℃-30℃ Humidity: 10% -90% non-condensing

Reference: RBD-2393

Brand: Raspberry Pi Official

Raspberry Pi Pico W with Soldered Headers

2 reviews

The Raspberry Pi Pico W builds upon the great cost-for-performance metrics of the Pico and add WiFi to the board. The Pico W features the same attributes as the Raspberry Pi Pico and also incorporates an Infineon CYW43439 wireless chip. CYW43439 supports IEEE 802.11 b/g/n wireless LAN, and Bluetooth® 5.2. (6/30/2022: Only Wireless LAN is supported on the...

Reference: RBD-2485

ESP32 Arduino LVGL WIFI & Bluetooth Development Board 2.8" 240*320 Smart Display Screen

ESP32 development board with 2.8" TFT LCD display Dual-core CPU, clock frequency up to 240MHz Supports LVGL, Arduino, and Wi-Fi and Bluetooth

Reference: RBD-0687

BMP280 Pressure Sensor Module

10 reviews

Operating Voltage: 1.71V to 3.6V – would typically be operated from 3.3V. Operating Temperature: -40 to +85 deg. Celsius (full accuracy between 0 and +65 deg. C). Peak current: 1.12mA. RoboticsBD Operating Pressure: 300 hPa to 1100 hPa. Accuracy between 700 to 900hPa and 25 to 40 deg. C: ±0.12hPa and ±1.0m.

Reference: RBD-2490

Arduino Ethernet Shield W5100 R3

1 review

Support TCP/IP protocol: TCP, UDP, ICMP, IPv4 ARP, IGMP, PPPoE and Ethernet Built-in 10BaseT/100BaseTX Ethernet physical layer Support automatic communication handshaking(full duplex and half duplex), Support automatic MDI/MDIX, automatically revise signal polarity Support ADSL connection (support PAP/CHAP certification mode in PPPoE protocol), Support...

Reference: RBD-0689

LM75A IIC I2C High Accuracy Digital Temperature Sensor

1 review

Operating Voltage: 2.8 V to 5.5 V Accuracy: ± 1.5°C Zero power resistance: 100 KΩ Operating temperature range: -55 ~ +125 ℃

Reference: RBD-2545

Quectel EC200A-CN LTE Cat4 Module GSM GPRS MINI 4G To RJ45 Kit With 100M Ethernet Port

Quectel EC200A-CN LTE Cat4 Module GSM GPRS MINI 4G To RJ45 Kit With 100M Ethernet PortEC200ACNDA: (China and India) FDD: B1/B3/B5/B8 TDD:B34/B38/B39/B40/B41 WCDMA:B1/B5/B8 GSM:B3/B8 IPEX1 generation 4G antenna interface

Reference: RBD-0691

IR Infrared Remote Decoder Encoding Transmitter & Receiver Wireless Module

2 reviews

Supply voltage: 5V Communication: Serial communication (TTL level) Operating istance: 6-10 meters 

Reference: RBD-2651

Wemos D1 Mini V3

D1 Mini board with 4 MB flash memory and ESP8266 chipset. The board can be programmed with Arduino IDE, has the CH340 USB chipset and allows you to create IoT devices quickly and easily.

Reference: RBD-0693

Infrared Line Track Tracker Follower Sensor

8 reviews

Operating Voltage: 3-5.5V Supply Current: ≥ 20mA Optimal Sensing Distance: 3mm Working voltage of 5V, the output of the black line low, white line of high output Uses Infrared Light to Detect Anti-Interference Ability Sensors to adopt TCRT5000 High Sensitivity, Stable Performance Exquisite workmanship, with the indicator Has a fixed bolt hole for easy...

Reference: RBD-2652

Wemos D1 Mini NodeMCU

Firstly, In terms of pins, the D1 Mini and NodeMCU V3 development boards are quite similar. They both break out all ESP8266 ESP-12E/F pins. The NodeMCU V3 board has additional 3V3 and GND pins. Hence,  it is more suitable for various connections to devices with an additional button for the flash. A high-quality USB cable is essential for this board to...

Reference: RBD-0695

MAX31865 SPI RTD PT100 to Digital Converter Module

Integration Lowers System Cost, Simplifies Design Efforts, and Reduces Design Cycle Time High Accuracy Facilitates Meeting Error Budgets 15-Bit ADC Resolution; Nominal Temperature Resolution 0.03125NC (Varies Due to RTD Nonlinearity) Total Accuracy Over All Operating Conditions:

Reference: RBD-2684

L701 Microcomputer AC 240 V LCD Digital Display Programmable Electronic Timer Switch

100% brand new and high quality. Widely used in street lights, neon lights, bells, radio and television equipment, production equipment, electrical equipment and household appliances automatic control. Built-in high-performance batteries as backup power in case of no electricity can still maintain time display and storage of. Auto timer error correction....

Reference: RBD-2685

Digital LCD All Week Programmable Timer DC 12V 16A SPST

Specifications: Color: White Material: ABS Dimensions: 60 x 48 x 32mm Output: 12V Power Consumption: 7.5VA Time Range: 1-168 hours Display: LCD Battery: Built-in 1.2V, 40mA Ambient Temperature: -25°C to 55°C Connection Type: Plug-in CN101A

Reference: RBD-2764

ESP32-S3-WROOM-1-N16R8 UNO Development Board For DevKitC-1

The ESP32-S3-WROOM-1-N16R8 is a versatile Wi-Fi and low-power Bluetooth MCU module, featuring the advanced ESP32-S3 series chip. With its powerful performance, rich peripheral interfaces, and support for popular programming methods, this module offers a wide range of applications in various fields including IoT, AI, and smart devices.

Reference: RBD-0816

VL6180 VL6180X ToF Range Finder Sensor

1 review

Power Supply Voltage: 3.3V~5V Operating Current: ＜5mA Measuring Distance: 5-100mm VCSEL light source Strong anti-interference Based on DFrobot Fermion VL6180X ToF Distance Ranging Sensor (Breakout)

Reference: RBD-2765

ESP32-S3 CAM Development Board WiFi Bluetooth Module N16R8 OV5640 Camera

The ESP32-S3 WROOM Development Kit 2 is a comprehensive development solution based on the ESP32-S3-WROOM-1 module, featuring an onboard PCB antenna and advanced peripherals. This kit comes bundled with an OV5640 camera, providing a complete hardware platform for prototyping and developing IoT, AI, and wireless communication applications.

Reference: RBD-0823

Optical Sensitive Resistance Light Detection Photosensitive LDR Sensor Module

30 reviews

LDR module 4 PIN Operating voltage 3.3V-5V Signal output indicator light. LDR module 4 PIN Able to detect ambient brightness and light intensity Adjustable sensitivity (via blue digital potentiometer adjustment)