Reference: RBD-0195

Brand: RoboticsBD

25mW Infrared Line Laser Light

25mW Infrared Line Laser Light

Reference: RBD-1670

ESP8285 IR Infrared Transmitter Receiver Module WIFI Remote Control Switch

The smallest 802.11b/g/n Wi-Fi SoC module Uses low power 32bit CPU and compatible with the application processor Main frequency up to 160MHz Built-in 10Bit high precision ADC Support UART/GPIO/PWM/ADC interface Integrate Wi-Fi MAC/BB/RF/PA/LNA

Reference: RBD-1928

HC-08 Bluetooth 4.0BLE Serial Port Module

Frequency: 2.4GHz ISM. Protocol: BLE 4.0. Max transmitting power: max. 4dBm. Modulation System: GFSK. Serial Baud Rate: 1200 to 115200 bps. Reference Distance: 80 meters.

Reference: RBD-2064

SIM800L NEW GPRS GSM Module Core Board Quad-band TTL Serial Port with the antenna

3 reviews

TTL serial port for serial port, you can link directly to the micro-controller. Don’t need MAX232. Power module automatically boots, homing network. Onboard signal lights all the way. It flashes slowly when there is a signal, it flashes quickly when there is no signal. Note: If you want to buy the cheaper recycled SIM800L Module Click here.

Reference: RBD-2212

TEA5767 Stereo FM Radio Module with Detachable Antenna

Directly plug antenna interface. I2C bus communication. Multi-capacitor combined filter. Blue LED power indicator. High sensitivity(low noise RF input amplifier). High power auto gains control AGC circuit.

Reference: RBD-0624

FM Radio Transmitter Module Wireless Microphone Surveillance Frequency 88-108MHz

Operating Voltage: DC 2V- 9V  Operating frequency: 85MHZ - 115MHZ Output Impedance: 50 ohms

Reference: RBD-2359

CC1101 500kbps Wireless Transceiver Module RF 433mhz SPI Interface SMA Antenna

This is a self-developed, small-size, 433 MHz DIP wireless module with a maximum tx power of 10mW based on CC1101 of Texas Instruments. Due to the adoption of the very mature CC1101 as the core chip, its stability has been unanimously praised by user. The module is mainly used in smart home, industrial, scientific research and medical, as well as...

Reference: RBD-2397

GPS Module NEO-6M Satellite Positioning Module for Arduino with MicroUSB

2 reviews

GPS Module NEO-6M Satellite Positioning Module for Arduino with MicroUSB

Reference: RBD-2488

W5100 Ethernet Network Module for Arduino

1 review

Support Hardwired TCP/IP Protocols: TCP, UDP, ICMP, IPv4 ARP, IGMP, PPPoE, Ethernet 10BaseT/100BaseTX Ethernet PHY embedded Auto-Negotiation (Full-duplex and half duplex) Support Auto MDI/MDIX Simultaneously Supports to 4 independent sockets 0.18 µm CMOS technology 3.3V operation with 5V I/O signal tolerance Provide Serial Peripheral Interface (SPI MODE...

Reference: RBD-0368

Force Sensitive Resistor 0.5"

2 reviews

Thickness: 0.4mm Trigger Force: 20g, triggered (default resistance<200kΩ)  Pressure Measuring Range: 20g~6kg Static Pressure & Dynamic Pressure Measurement (within the frequency of 10Hz) Initial Resistance: >10MΩ Activation Time: <0.01S Operating Temperature: -40°C~+85°C  Lifespan: >1million times Hysteresis: +10%，(RF+ -RF-)/FR+，1000g...

Reference: RBD-2489

Wiznet W5500 Mini Ethernet Network Module

1 review

Wiznet Compact W5500 Network Module - 10/100 Base T WIZ850io is a compact size network module that includes a W5500 (TCP/IP hardwired chip and PHY embedded), a transformer and RJ45. It can be used as a component and no effort is required to interface W5500 and Transformer. The WIZ850io is an ideal option for users who want to develop their Internet...

Reference: RBD-2562

Open Smart Long Range 433Mhz RF Wireless Transceiver Kit For Arduino

The kit includes one pair of transmitter and receiver modules for increasing the communication distance. And the frequency is 433MHz. It is very popular for remote control systems, such as wireless doorbell, remote control rolling gates, smart car, smart home, etc.

Reference: RBD-2819

GPS Embedded Antenna - SMA Male

Superior Signal Strength: Powerful 26dB gain LNA antenna for exceptional GPS reception. Compact Design: Ideal for integrating GPS functionality into space-constrained projects. Easy Integration: Unpackaged design with SMA connector simplifies setup. Durable Construction: Built to withstand moderate vibrations.

Reference: RBD-1750

Instrumentation Voltage Amplifier Module AD620

2 reviews

Operating Voltage: 3- 12 VDC Amplification: Adjustable 1.5~1000 times Signal Input Voltage Range: 100µV~300mV Signal Output Range: 100µV~300mV

Reference: RBD-2163

6V 30:1 500RPM Micro Metal Gearmotor w/ Encoder

1 review

Built-in encoder Average output up to 420 pulses per revolution The brass faceplate has two mounting holes threaded Long D profile metal output shaft (0.354"/9.0 mm)

Reference: RBD-2290

PS2 Game Rocker Push Button Module for Arduino

X, Y axis output is two potentiometers, can read the twist angle through AD conversion. Press the rocker downward, you can move a touch switch, for digital output, has been pulled up. The original OMRON button has long life and good handle. It is suitable for two degrees of freedom steering gear pan tilt control or other remote control proportional...

Reference: RBD-2291

2 Channel PS2 Game Rocker Push Button Module For Arduino

1 review

Functional configuration: 2 PS2 game joysticks (2 analog voltages per channel) 1 digital level) 2 independent buttons (original button)   Product Features: The X and Y axes output are two potentiometers, and the twist angle can be read by AD conversion. Press the rocker down to send a touch switch, for digital output, has been pulled up Original Omron...

Reference: RBD-2320

Servo Motor MG996R 360 Degree Continuous Rotation

1 review

The  MG996R is an industry standard for high torque servos. The metal gearing gives a stalling torque of a high 10kg in a small package. The MG996R 360° has the ability to rotate continuously though 360° in both directions. This makes this servo perfect for robotics or even the rotation of camera sliders! Continuous rotation servos are like regular...

Reference: RBD-2414

Yahboom 4 Channel Infrared Line Following Tracking Sensor Module

1 review

This tracking module adopts four tracking probes, and optimized spacing layout. The inner two probes can accurately identify the black line. The outer two probes can assist the inner probe to identify the black line and provide early warning. The car can recognize the 90°curved road and other difficult tracks. Knob-type adjustable resistors plus...

Reference: RBD-2459

5A Adjustable Step Down CC / CV Module

Converts 5 – 30V down to a 0.8 – 29V output with adjustable current limit

Reference: RBD-2515

5V Electromagnet - 5 Kg Holding Force - P25/20

Nominal Voltage: 5V DC Current Draw: 0.6 Amps at 5V Holding Force: 5 Kg / 11 lb Approximate Pickup Weight: 1 Kg / 2 lbEver wanted to feel like Magneto? Well, now you sort of can! Bring the ferromagnetic objects in the world under your control with an Electromagnet The simplest way to make an electromagnet is to get a solenoid, pass some current through...

Reference: RBD-2516

5V Electromagnet - 2.5 Kg Holding Force - P20/15

Nominal Voltage: 5V DC Current Draw: 0.6 Amps at 5V Holding Force: 2.5Kg / 5.5lb Approximate Pickup Weight: 0.45 Kg / 1 lbEver wanted to feel like Magneto? Well, now you sort of can! Bring the ferromagnetic objects in the world under your control with an Electromagnet The simplest way to make an electromagnet is to get a solenoid, pass some current...

Reference: RBD-2518

Plastic Water Solenoid Valve - 12V - 1/2" Nominal

1/2" Nominal NPS Working Pressure: 0.02 Mpa - 0.8 Mpa Working Temperature: 1 ℃ - 75 ℃ Response time (open): ≤ 0.15 sec Response time (close): ≤ 0.3 sec Actuating voltage: 12VDC Actuating life: ≥ 50 million cycles

Reference: RBD-2541

Brand: DFRobot

Gravity: Voice Recorder Module

This is the latest voice recorder module with integrated record and play functions. Easily record your voice by pressing the record button, speaking and then releasing the button when finished. The module is able to playback 10 seconds in total. Connect an 8Ω 3W speaker or an external active speaker for voice output. The module also has a 3 pin digital...

Reference: RBD-2754

L298N 4WD Motor Driver DC Motor Driver Compatible With 3.3V Support Arduino STM32

The L298N 4WD Motor Driver is a versatile and robust H-bridge driver module designed for controlling DC motors with ease and precision. With its compatibility with 3.3V microcontrollers and support for popular platforms like Arduino and STM32, this module offers flexibility and convenience in motor control applications.