Reference: RBD-2819

GPS Embedded Antenna - SMA Male

Superior Signal Strength: Powerful 26dB gain LNA antenna for exceptional GPS reception. Compact Design: Ideal for integrating GPS functionality into space-constrained projects. Easy Integration: Unpackaged design with SMA connector simplifies setup. Durable Construction: Built to withstand moderate vibrations.

Reference: RBD-1552

868MHz RF LoRa SX1276 Long-Distance Communication Module

Working Frequency: 868 MHz Distance: 8000m RF IC: SX1276

Reference: RBD-1670

ESP8285 IR Infrared Transmitter Receiver Module WIFI Remote Control Switch

The smallest 802.11b/g/n Wi-Fi SoC module Uses low power 32bit CPU and compatible with the application processor Main frequency up to 160MHz Built-in 10Bit high precision ADC Support UART/GPIO/PWM/ADC interface Integrate Wi-Fi MAC/BB/RF/PA/LNA

Reference: RBD-0440

HC-12 433Mhz Wireless Serial Transceiver Module - 1 Kilometer

433MHz operation Ultra-low power consumption (3.5mA or 22mA depending on mode) with sleep option (80μA). 10dBm output power and high sensitivity providing long range in the open environment. 3V-6V operating voltage. Serial pass-through mode to replace the serial cable (half duplex). IO pass-through modes. RoboticsBD

Reference: RBD-0389

PL2303 USB to TTL Serial Converter

Adopt imported controller PL2303HX, which can stabilize the flash with high speed 500mA self-recovery fuse for protection Two data transmission indicator can monitor data transfer status in real time Reserve 3.3V and 5V pin interface, easy for the DDWRT of different voltage system that needs power The entire board is coated by the high quality transparent...

Reference: RBD-0718

FlySky FS-CT6B 2.4GHz 6CH Transmitter With Receiver FS-R6B Mode 2

Model Type: Digital Radio Transceiver. Sensitivity: 1024. Bandwidth: 500 kHz. Default Operating Mode: Mode 2 (Left-Hand Throttle). No. of Channels: 6. Operating Voltage: 12V DC (1.5AA x 8 Battery) (not included).

Reference: RBD-0658

FTDI USB to TTL Serial Converter Adapter FT232RL

Standard interface layout, compatible with a variety of Arduinos such as the Pro Mini Original FTDI FT232 chip, stable performance USB power has current protection, using 500MA self-restore fuse RXD/TXD transceiver communication indicator With power, sending, receiving indicator, working status LED indicators Mini USB Port Connection Support 3.3V, 5V...

Reference: RBD-0040

Arduino Bluetooth Module HC-06

Bases at CSR BC04 Bluetooth technology. with build-in 2.4GHz PCB antenna It’s at the Bluetooth class 2 power level. Range test: 10 meters Operating voltage: 3.3V to 6V DC Operating current in pairing is in the range of 30~40mA.

Reference: RBD-2817

U.FL to U.FL - 200mm Mini Coax Cable

Ultra-Compact Size: 200 mm (approximately 8 inches) in length, perfect for connecting devices in confined spaces. Direct U.FL Connection: Eliminates the need for bulky adapters, ideal for connecting U.FL equipped devices. Exceptional Flexibility: 1.25mm diameter cable offers easy maneuvering for intricate installations. 50Ω Impedance: Ensures efficient...

Reference: RBD-0729

GPS Antenna 1575.42 MHz

Frequency (MHz) 1575 +/- 5 MHz Gain > 28 dBi (with LNA) Impedance (Ω) 50 Ω VSWR < 1.5 Polarization RHCP Power Handling (W) 50 watts Cable Length: 3Meter Connector: SMA-Male

Reference: RBD-0443

GPRS GSM SIM900 Arduino Shield

Based on SIMCom‘s SIM900 Module Quad-Band 850 / 900/ 1800 / 1900 MHz - would work on GSM networks in all countries across the world. Control by AT commands - Standard Commands: GSM 07.07 & 07.05 | Enhanced Commands: SIMCOM AT Commands. Short Message Service - so that you can send small amounts of data over the network (ASCII or raw hexadecimal).

Reference: RBD-0797

U-Blox NEO-6M GPS Module

5Hz position update rate. The cold start time of 38 s and Hot start time of 1 s. Configurable from 4800 Baud to 115200 Baud rates. (default 9600). SuperSense ® Indoor GPS: -162 dBm tracking sensitivity. Support SBAS (WAAS, EGNOS, MSAS, GAGAN). Separated 18 x 18mm GPS antenna. RoboticsBD In recent years 2022, due to a shortage of chips, some of the GPS...

Reference: RBD-0733

RP-SMA to U.FL Adapter RF Cable - Female 150mm

Connects Devices & Antennas: Ideal for WiFi, Bluetooth, and nRF devices to 2.4GHz antennas. Enhanced Usability: 150mm length (compared to standard 100mm) provides more flexibility for enclosure integration. Reliable Signal: 50Ω impedance ensures efficient signal transmission. Durable Construction: Built with high-quality materials for long-lasting...

Reference: RBD-0841

A6 GPRS GSM Module

Supports Quad-band: GSM850, EGSM900, DCS1800 and PCS1900 Connect onto any global GSM network with any 2G SIM Make and receive voice calls using an external 8Ω speaker & electret microphone Facility to connect 4-pole TRRS mic and headset

Reference: RBD-2815

SMA to U.FL Adapter RF Cable - Female 100mm

Connects Antennas: Ideal for connecting external antennas to devices with U.FL connectors. Improved Signal: 50Ω impedance and RG178 cable ensure reliable signal transmission. Durable Construction: Pure copper conductor and brass connectors for long-lasting performance. Compact Design: 100mmlength offers flexibility for various placements.

Reference: RBD-0369

Brand: SparkFun Electronics

XBee Pro 63mW RPSMA - Series 2B (ZigBee Mesh)

Supports binding and multicasting for home automation Mesh-network topology 2.4 GHz for worldwide deployment Common XBee footprint fits Parallax XBee Adapters and the Propeller Activity Board Firmware upgrades via UART, SPI or over the air TRANSCEIVER CHIPSET: SiliconLabs EM357 SoC DATA RATE: 250kbps Max RATED OUTDOOR/RF LINE-OF-SIGHT RANGE: Up to 2 mile...

Reference: RBD-1641

Dual Band GSM Antenna (SMA MALE)

Product: GSM Antenna Color: Black SMA male straight 5cm 900-1800MHz radio antenna. Frequency: 900MHz – 1800MHz Maximum Power: 50W Length: 5cm/1.97 inch

Reference: RBD-2349

Kinetic Self Powered Wireless Switch Receiver Long-Distance 433MHz Battery-Free ON/OFF Control Module 220V

Wireless Switch 433Mhz SmartHome Kinetic Switch Receiver 100V~ 250V Module Self Powered No Battery Need Wireless ONOFF Co Long distance, wiring free, IP68 waterproof wireless switch。Our self-generating wireless switch adopts the link mode of 433 protocol. The outdoor effective distance is 100 meters, and the indoor effective distance is between 30 and 50...

Reference: RBD-2928

RF Transceiver Radio Module nRF905 433/868/915MHz with Antenna

Radio module (transmitter and receiver) operating in 433 MHz band with SPI communication interface. Powered by 2.7 V - 3.3 V, the outputs are goldpin connectors.It has an external antenna with SMA connector.

Reference: RBD-1037

SIM808 GPRS/GSM+GPS Shield

Quad-band 850/900/1800/1900MHz Inner MT3337 GPS receiver, -165dBm precision, control on a same serial port. Earphone/ microphone outputs on a card or external 32-ohm speaker + supports voice calls with an electret microphone. Sending and receiving SMS.

Reference: RBD-2562

Open Smart Long Range 433Mhz RF Wireless Transceiver Kit For Arduino

The kit includes one pair of transmitter and receiver modules for increasing the communication distance. And the frequency is 433MHz. It is very popular for remote control systems, such as wireless doorbell, remote control rolling gates, smart car, smart home, etc.

Reference: RBD-2784

Quad-band Cellular Antenna SMA 7.75inch - Male

Supports GSM, DCS, and PCS bands (824MHz to 1990MHz) for compatibility with most cellular networks. Built to withstand harsh environments with a brass body, brass contact, and a weatherproof insulator. Features a standard SMA connector for simple connection to your cellular device. 7.75-inch size makes it ideal for portable applications or discreet...

Reference: RBD-0579

GPS GSM GPRS SIM808 Module (Arduino Compatible)

Quad-band 850/900/1800/1900MHz GPRS multi-slot class12 connectivity: max. 85.6kbps(down-load/up-load) GPRS mobile station class B Controlled by AT Command (3GPP TS 27.007, 27.005 and SIMCOM enhanced AT Commands) Supports charging control for Li-Ion battery Supports Real-Time Clock Integrated GPS/CNSS and supports A-GPS Low power consumption, 10mA in sleep...

Reference: RBD-2295

CC2530+CC2591 Zigbee Module Wireless Power Amplification Development Board with SMA Antenna

The CC2530 ZigBee series wireless module launched by BEE Iot Technology is a ZigBee RADIO frequency module developed based on TI's CC2530F256 chip. The module can complete ZigBee learning, project application, and industrial production, and can be widely used in the field of short-distance wireless communication networking. It can build powerful network...

Reference: RBD-2760

RS422 to TTL Power Supply Converter Board

RS422 interface, two-way communication. B Y Z A ultra far transmission 1000 meters The module has ESD 15KV protection. Onboard to increase the limit of 10 ohms current limiting current protection. Module with TVS diode. Anti lightning, peak voltage. The module has 120-ohm termination resistors, which can effectively reduce the interference of long-range...

Reference: RBD-2368

CC1101 433mhz 100mW SMA Antenna E07-M1101D-SMA uhf Wireless Transceiver Module

This is a self-developed, small-size, 433 MHz DIP wireless module with a maximum tx power of 10mW based on CC1101 of Texas Instruments. Due to the adoption of the very mature CC1101 as the core chip, its stability has been unanimously praised by user. The module is mainly used in smart home, industrial, scientific research and medical, as well as...

Reference: RBD-1806

LILYGO® TTGO T-Display ESP32 WiFi And Bluetooth Development Board

Based on ESP32 240MHz Xtensa dual-core 32-bit microprocessor Operating Voltage: 2.7V – 4.2V Working Current: 60mA Battery Charging Current: 500mA

Reference: RBD-1039

SIM800L Mini GPRS GSM Module

The module was recycled from a mobile phone so you can say it is used. TTL serial port for serial port, you can link directly to the micro-controller. Don’t need MAX232. Power module automatically boots, homing network. Onboard signal lights all the way. It flashes slowly when there is a signal, it flashes quickly when there is no signal. In recent years...

Reference: RBD-0621

USB to Mini USB Cable 1M - Arduino NANO

Connects Your Arduino Nano: Provides essential connection between your Arduino Nano and a computer for programming and power. Standard Compatibility: Features USB Type-A and Mini-B connectors for universal computer connectivity. Reliable Performance: Solid workmanship and high-quality materials ensure dependable data transfer. Flexible Design: 1-meter...

Reference: RBD-2772

E83-2G4M03S-TB Bluetooth Mesh Module Test Suite

Used to test and develop Chengdu Ebyte E83-2G4M03S wireless module. E83-2G4M03S-TB has been pre-soldered to E83-2G4M03S. Please refer to the module manual for detailed usage. All IO ports of the E83-2G4M03S wireless module have been led out. The module is equipped with CH340X serial port chip, which can directly carry out serial communication development....