Reference: RBD-1354
Jumper Wire Single 20cm
Length: 8 inches/20 CM (Long) Material: Copper Plated Pin Spacing: 2.54mm.
Reference: RBD-1354
Length: 8 inches/20 CM (Long) Material: Copper Plated Pin Spacing: 2.54mm.
Reference: RBD-0351
Contactless transmission of data and supply energy (no battery needed) Operating distance: Up to 100mm (depending on antenna geometry) RoboticsBD Operating frequency: 13.56MHz Data transfer: 106 kbit/s Data integrity: 16 Bit CRC, parity, bit coding bit counting Anticollision Typical ticketing transaction: <100 ms ( including backup management)...
Reference: 0245
Choose your desire Resistor value from below:
Reference: 0031
3 Types Available (Please select from option) 1. Male to Male 2. Male to Female 3. Female-Female
Reference: RBD-0768
Size: 5mm Color: RED Head Shape: Round Lens Appearance: Transparent
Reference: RBD-0761
Breadboard friendly Mounting Style: Through Hole Mounting Direction: Vertical
Reference: 1353
Length: 12.5 inches/30 CM (Long) Material: Copper Plated Pin Spacing: 2.54mm.
Subcategories
Reference: RBD-0166
Description: This is the very popular 2.4GHz XBee module from Digi. These modules take the 802.15.4 stack (the basis for Zigbee) and wrap it into a simple to use serial command set. These modules allow very reliable and simple communication between microcontrollers, computers, systems, really anything with a serial port! Point to point and multi-point...
Reference: RBD-0709
6000 Counts True RMS voltage and current measurements Capacitance, Resistance, Buzzer, Diode
Reference: RBD-0724
PC-CABLE 6ED1057-1AA01-0BA0 ---------------------------------------------------------- এই ক্যাবলটি আমাদের কাছে বিক্রির জন্য স্টকে নেই। কিন্তু আপনার PLC তে কোন সমস্যা অথবা প্রোগ্রামিং করার প্রয়োজন হলে আমাদের সাথে যোগাযোগ করতে পারেন। Please Contact: 01705-760637
Reference: RBD-0233
Brand: SparkFun Electronics
Description: This is the LSM9DS0, a versatile motion-sensing system-in-a-chip that houses a 3-axis accelerometer, 3-axis gyroscope, and 3-axis magnetometer. That’s right, 9 degrees of freedom (9dof) from a single IC!
Reference: RBD-0378
Model: Eachine 1000TVL 1/3 CCD Lux: 0.08Lux/ F1.2 Sensor: 1/3 “CCD Format: NTSC/PAL(Free switch) Resolution: a.Ultra High Definition 1000TVL b.PAL: 976H X 582V c.NTSC: 976H X 494V Lens: 2.8mm IR coated. RoboticsBD FOV: 110 °
Reference: RBD-0412
Microchip's PICkit3 In-Circuit Debugger/Programmer uses in-circuit debugging logic incorporated into each chip with Flash memory to provide a low-cost hardware debugger and programmer. The MPLAB PICkit3 allows debugging and programming of PIC® and dsPIC® Flash microcontrollers at a most affordable price.
Reference: RBD-0419
Features: Built-in Red, IR, and Green LEDs 5V operation (3.3V is allowed, but green LED is not guaranteed to operate) Applications include presence detection, distance sensing (18" max), pulse oximetry, blood oxygen saturation level (SpO2), smoke and particle detection Documents: Schematic Eagle Files Hookup Guide Datasheet (MAX30105) MAX3010x Sensor...
Reference: RBD-0235
Brand: SparkFun Electronics
Description: This is a framed graphical LCD 64x128 with LED backlight. This unit is a very clear STN type LCD with a simple command interface. This new module includes the negative voltage circuitry on board!
Reference: RBD-0334
The 9DOF MPU-9150 is the world’s first 9-axis MotionTracking MEMS device designed for the low power, low cost, and high performance requirements of consumer electronics equipment including smartphones, tablets and wearable sensors. And guess what? You get to play with it.
Reference: RBD-1310
Supply voltage 2.8 - 3.4 V Transmit current (typical) 340 mA (@3.3 V) (180 mA for international variant) Idle/receive current (typical) 55 mA (@ 3.3 V) Power-down current < 10 uA
Reference: RBD-0821
UBLOX NEO-7M Tracking sensitivity: 161 dBm UBLOX NEO-7M Capture sensitivity : 148 dBm UBLOX NEO-7M cold start time: 38s average UBLOX NEO-7M Warm start time: 35s average UBLOX NEO-7M hot start time: 1s average UBLOX NEO-7M Capture time: 0.1s Average Compass Stand Holder Material: CNC Aluminum alloy, carbon glass fiber rod Compass Stand Holder Mounting rod...
Reference: RBD-1140
Open-source single-board computer. Android 4.4. Ubuntu. Debian. Raspbian Image. AllWinner H3 SoC. 512GB DDR3 SDRAM.
Reference: 1316
Tougher and stronger Less warping (about 0.4% compared to over 8% in regular ABS) Prints smoother & smoother printed objects Better scratch, heat and oil resistance Can be polished using acetone Can be easily colored.
Reference: RBD-1387
Memory Size: 128 Gigabyte Card Type: Micro SD Speed: up to 95MB/s Class: 10 High-speed Card can be used for both Mobile phone and Raspberry Pi
Reference: RBD-1315
Great bio-compatibility, excellent transparency and environment-friendly Low shrinkage, good round shape Accurate diameter (±0.02mm) Easy to print with stable printing performance Various colors are available 100% bio-degradable and FDA food safety approved
Reference: 1317
TPU rubber based Material. Very flexible and elastic. Shore A Hardness at 87A. Tensile Strength 52 MPa.
Reference: RBD-1386
Brand: Anycubic
Wavelength(nm): 395-405 Color: Black Density(g/m^3): 1.08-1.13 Hardness(Shore D):79.0 Tensile Strength(MPa): 46-67 Elongation at Break(%):28-35
Reference: RBD-2619
Compact and lightweight (36.6g) micro FPV quadcopter Indoor and Outdoor flying. Stable and precise control Durable frame design with easy motor replacement (connectors pre-soldered).
Reference: RBD-0186
(Retired) WiDo - Arduino WIFI IoT(Internet Of Things) Node (Arduino Compatible) Wido is an Arduino compatible WIFI IoT Node development board, which integrates with WG1300 WIFI solution. The microcontroller of Wido is ATMEL ATmega32U4.
Reference: RBD-2350
Waterproof Wireless Switch 433MHz Self-Powered Remote Control Switch Battery-Free Wall Light Switch
Reference: RBD-2674
Brand: DSSERVO Model: DS3218MG Stall Torque (5V): 19 kg/cm (263.8 oz/in) Stall Torque (6.8V): 21.5 kg/cm (298.5 oz/in) Dead Band: 3μs Speed: 0.16 sec/60°(5V) / 0.14 sec/60°(6.8V) Operating Voltage: 4.8 ~ 6.8 DC Volts Weight: 60 g (2.12 oz) Motor Type: DC Motor Gear Type: Copper & Aluminum270 Degree Angle
Reference: RBD-0586
Emerson PLC programming cable Robotics Bangladesh ---------------------------------------------------------- এই ক্যাবলটি আমাদের কাছে বিক্রির জন্য স্টকে নেই। কিন্তু আপনার PLC তে কোন সমস্যা অথবা প্রোগ্রামিং করার প্রয়োজন হলে আমাদের সাথে যোগাযোগ করতে পারেন। Please Contact: 01705-760637
Reference: RBD-0590
LG PLC Programming Cable for K120 K80 ---------------------------------------------------------- এই ক্যাবলটি আমাদের কাছে বিক্রির জন্য স্টকে নেই। কিন্তু আপনার PLC তে কোন সমস্যা অথবা প্রোগ্রামিং করার প্রয়োজন হলে আমাদের সাথে যোগাযোগ করতে পারেন। Please Contact: 01705-760637
Reference: RBD-0591
Mitsubishi PLC Cable USB-SC09 Robotics Bangladesh ---------------------------------------------------------- এই ক্যাবলটি আমাদের কাছে বিক্রির জন্য স্টকে নেই। কিন্তু আপনার PLC তে কোন সমস্যা অথবা প্রোগ্রামিং করার প্রয়োজন হলে আমাদের সাথে যোগাযোগ করতে পারেন। Please Contact: 01705-760637
Reference: RBD-0593
NN-CNV3 Fuji Flex-PC NB/NJ/NS/NW0 PLC Cable ---------------------------------------------------------- এই ক্যাবলটি আমাদের কাছে বিক্রির জন্য স্টকে নেই। কিন্তু আপনার PLC তে কোন সমস্যা অথবা প্রোগ্রামিং করার প্রয়োজন হলে আমাদের সাথে যোগাযোগ করতে পারেন। Please Contact: 01705-760637
Reference: RBD-0739
Brand: Raspberry Pi Official
Fully HAT compatible 40pin GPIO (Unpopulated) Stream and watch Hi-definition video output at 1080P 512MB RAM and Micro SD Slot for OS Tiny Current Draw ~ 140mA at 5V! Mini-HDMI for Video Micro-USB OTG Host for Data and Power Micro-CSI Camera Port On-Board Bluetooth and WiFi.
Reference: RBD-0594
Omron PLC Cable Com-port CPM Robotics Bangladesh ---------------------------------------------------------- এই ক্যাবলটি আমাদের কাছে বিক্রির জন্য স্টকে নেই। কিন্তু আপনার PLC তে কোন সমস্যা অথবা প্রোগ্রামিং করার প্রয়োজন হলে আমাদের সাথে যোগাযোগ করতে পারেন। Please Contact: 01705-760637
Reference: RBD-1581
Model:UT201 DC Voltage: 200mV / 2V / 20V / 200V / 600V AC Voltage: 2V / 20V / 200V / 600V AC Current: 2A / 20A / 200A / 400A Resistance: 200 Ohm / 2 kOhm / 20 kOhm / 200 kOhm / 2 MOhm / 20 MOhm Auto range and 3/s sampling rate Data hold, Max value hold Auto power off Low battery prompt; over-range prompt and auto polarity display
Reference: RBD-0013
Arduino Programming Supports fuses and lock bit programming Upgradeable for future device support Supports target voltages from 1.8V to 5.5V Adjustable ISP programming speed (50Hz to 8MHz SCK frequency) USB 2.0 compliant (full speed, 12Mbps) Powered from USB, does not require external power supply Target interface protection Short-circuit protection...
Reference: RBD-0598
Panasonic USB PLC Cable Robotics Bangladesh ---------------------------------------------------------- এই ক্যাবলটি আমাদের কাছে বিক্রির জন্য স্টকে নেই। কিন্তু আপনার PLC তে কোন সমস্যা অথবা প্রোগ্রামিং করার প্রয়োজন হলে আমাদের সাথে যোগাযোগ করতে পারেন। Please Contact: 01705-760637
Reference: RBD-0100
Description: This robotic claw is a step up from the classic. The MKII takes everything you loved about the standard robot claw from DAGU and makes some significant improvements!