Reference: RBD-0166

XBee 1mW Trace Antenna - Series 1 (802.15.4)

Description: This is the very popular 2.4GHz XBee module from Digi. These modules take the 802.15.4 stack (the basis for Zigbee) and wrap it into a simple to use serial command set. These modules allow very reliable and simple communication between microcontrollers, computers, systems, really anything with a serial port! Point to point and multi-point...

Reference: RBD-0189

Brand: DFRobot

Xbee Shield for Arduino (without Xbee)

Xbee Shield for Arduino (without Xbee) INTRODUCTION: The XBee Expansion Board is a compliant solution designed to meet low-cost, low-power wireless sensor networks with special needs.The module is easy to use, low power consumption, and the provision of critical data between devices reliable transmission.

Reference: RBD-0196

Brand: DFRobot

APC220 Radio Communication Module 1KM Line of sight (LOS)

1 review

The APC220 radio module offers a cost-effective solution for wireless data communications, featuring an embedded high-speed microprocessor and high-performance IC. With its transparent UART/TTL interface, it eliminates the need for packetizing and data encoding, making it a popular choice among customers seeking better range performance at a low cost.

Reference: RBD-0237

APM /Pixhawk Radio Telemetry Kit 433Mhz 100mW

Description: This Telemetry radio set allows you to link to  a flight controller such as the APM or Multiwii  AIO via a USB equipped device such as a  computer, laptop or tablet supporting a USB  connection (OTG). APM /Pixhawk Radio Telemetry Kit 433Mhz 100mW (OTG Cable Included)

Reference: RBD-2294

JQ6500 V2.1 MP3 Player Module

JQ6500 MP3 Voice sound module can play stereo MP3 files or standard mono audio files. The module has two different modes to operate in; serial communication mode (connecting to a microcontroller) or AD button control mode (module can be controlled with switches).

Reference: RBD-2307

Stereo Enclosed Speaker 3W 8Ω

1 review

This speaker is a great addition to any audio project where you need 8 ohm impedance and 3W or less of power. We particularly like this speaker as it is small and enclosed for good audio volume and quality. It has a handy JST 2PH input cable to add audio to your displays and other projects (this connector is part of the JST-PH series which is ~2.0mm...

Reference: RBD-2318

Sound Output Module Speaker Module Microphone Sensor Module Sound Sensor for Arduino

The Speaker module is composed of a power amplifier and a loudspeaker. Sound size can be adjusted by the potentiometer on the circuit board. Enter different frequencies, the speakers produce different tones. Can be carried out by for Arduino encoding and DIY their music box!Product data interfaceusing anti plug,the two sides of the interface are...

Reference: RBD-2541

Brand: DFRobot

Gravity: Voice Recorder Module

This is the latest voice recorder module with integrated record and play functions. Easily record your voice by pressing the record button, speaking and then releasing the button when finished. The module is able to playback 10 seconds in total. Connect an 8Ω 3W speaker or an external active speaker for voice output. The module also has a 3 pin digital...

Reference: RBD-0201

FlySky 2.4Ghz 9CH RC Transmitter FS-TH9X (Upgrade)

1 review

QUICK OVERVIEW Transmitter: FS-TH9X Upgrade with FS-RM003 2.4GHz Module Receiver: FS-IA10B Default Mode: Mode-2 Input Power: 12V DC (1.5V x 8  AAA Battery) Bidirectional System Frequencies-Hopping Omni-directional High Gain Antenna Low Power Consumption

Reference: RBD-0282

XBee USB Adapter

Specifications: - 3.3V and 5V dual power output- 3.3V and 5V IO compatible- USB2.0 protocol- BitBang mode ready- Easily connected to PC via mini USB cable- Support XBee-setting with software X-CTU

Reference: RBD-2691

Through-Hole Speaker 15mm diameter - 2kHz range

Compact 15mm speaker for integrating sound into space-constrained projects. 2kHz frequency range suitable for basic audio applications. Through-hole mounting for easy integration with circuit boards. Handles up to 0.5W of power for moderate sound output.

Reference: RBD-2718

PAM 8610 Digital Stereo Class-D Amplifier Board 2x15W Output

Dual-Channel Stereo Output Run-on 7V to 15V power Supply 32 Steps DC volume control has a +32dB to -75dB range. 40 pin QFN 6 x 6 mm package. Much higher efficiency in terms of cost and performance than competitors’ ICs

Reference: RBD-2724

MAX4466 Electret Microphone Adjustable Amplifier Module

The MAX4466 Electret Microphone Module is a convenient and sensitive audio sensor solution designed for capturing sound waves and converting them into electrical signals. This module incorporates the MAX4466 electret condenser microphone and an integrated amplifier circuit, making it well-suited for applications requiring clear and amplified audio capture.

Reference: RBD-2747

Mini Speaker - PC Mount 12mm 2.048kHz

This is a small 12mm round speaker that operates around the audible 2kHz range. You can use these speakers to create simple music or user interfaces. This is not a true piezoelectric speaker but behaves similarly. Instead of a piezoelectric crystal that vibrates with an electric current, this tiny speaker uses an electromagnet to drive a thin metal sheet....

Reference: RBD-2758

MAX9814 Microphone Amplifier Module

With this module you can easily measure sound with an analog pin on your Arduino or other microcontroller. The module has an automatic gain/amplification (ACG) of the microphone: The module amplifies sounds with a low volume more, and sounds with a higher volume less.

Reference: RBD-2295

CC2530+CC2591 Zigbee Module Wireless Power Amplification Development Board with SMA Antenna

The CC2530 ZigBee series wireless module launched by BEE Iot Technology is a ZigBee RADIO frequency module developed based on TI's CC2530F256 chip. The module can complete ZigBee learning, project application, and industrial production, and can be widely used in the field of short-distance wireless communication networking. It can build powerful network...

Reference: RBD-2327

Brand: DFRobot

Self-powered Wireless Switch 433Mhz

In life, remote controllers can be seen everywhere, and most of them are inseparable from the battery. However, we often encounter problems when using the battery, for instance, it is troublesome to replace the battery, batteries are easy to corrode in a humid environment, or the waste batteries may cause serious environmental pollution. Do you know that...

Reference: RBD-2328

SIM A7670C R2 4G LTE GSM Module Compatible with STM32 Raspberry Pi

1 review

The A7670 series is the LTE Cat 1 module that supports wireless communication modes of LTE-TDD/LTE-FDD/GSM/GPRS/EDGE. It supports a maximum 10Mbps downlink rate and a 5Mbps uplink rate. The A7670 series supports multiple built-in network protocols, which are suitable for main IOT applications such as telematics, surveillance devices, POS, industrial...

Reference: RBD-2349

Kinetic Self Powered Wireless Switch Receiver Long-Distance 433MHz Battery-Free ON/OFF Control Module 220V

Wireless Switch 433Mhz SmartHome Kinetic Switch Receiver 100V~ 250V Module Self Powered No Battery Need Wireless ONOFF Co Long distance, wiring free, IP68 waterproof wireless switch。Our self-generating wireless switch adopts the link mode of 433 protocol. The outdoor effective distance is 100 meters, and the indoor effective distance is between 30 and 50...

Reference: RBD-2358

CC1101 500kbps Wireless Transceiver Module RF 433mhz SPI Interface Spring Antenna

This is a self-developed, small-size, 433 MHz DIP wireless module with a maximum tx power of 10mW based on CC1101 of Texas Instruments. Due to the adoption of the very mature CC1101 as the core chip, its stability has been unanimously praised by user. The module is mainly used in smart home, industrial, scientific research and medical, as well as...

Reference: RBD-2359

CC1101 500kbps Wireless Transceiver Module RF 433mhz SPI Interface SMA Antenna

This is a self-developed, small-size, 433 MHz DIP wireless module with a maximum tx power of 10mW based on CC1101 of Texas Instruments. Due to the adoption of the very mature CC1101 as the core chip, its stability has been unanimously praised by user. The module is mainly used in smart home, industrial, scientific research and medical, as well as...

Reference: RBD-2350

Waterproof Wireless Switch 433MHz Self Powered Remote Control Switch Battery-Free Wall Light Switch

Waterproof Wireless Switch 433MHz Self-Powered Remote Control Switch Battery-Free Wall Light Switch

Reference: RBD-2368

CC1101 433mhz 100mW SMA Antenna E07-M1101D-SMA uhf Wireless Transceiver Module

This is a self-developed, small-size, 433 MHz DIP wireless module with a maximum tx power of 10mW based on CC1101 of Texas Instruments. Due to the adoption of the very mature CC1101 as the core chip, its stability has been unanimously praised by user. The module is mainly used in smart home, industrial, scientific research and medical, as well as...

Reference: RBD-2396

GPS Module NEO-7M Satellite Positioning Module for Arduino with MicroUSB

1 review

GPS Module NEO-7M Satellite Positioning Module for Arduino with MicroUSB

Reference: RBD-2397

GPS Module NEO-6M Satellite Positioning Module for Arduino with MicroUSB

2 reviews

GPS Module NEO-6M Satellite Positioning Module for Arduino with MicroUSB

Reference: RBD-2456

nRF24L01 Breakout Adapter with Voltage Regulator

1 review

Breakout adapter includes a built-in 3.3V regulator and easy header hookup.

Reference: RBD-2488

W5100 Ethernet Network Module for Arduino

1 review

Support Hardwired TCP/IP Protocols: TCP, UDP, ICMP, IPv4 ARP, IGMP, PPPoE, Ethernet 10BaseT/100BaseTX Ethernet PHY embedded Auto-Negotiation (Full-duplex and half duplex) Support Auto MDI/MDIX Simultaneously Supports to 4 independent sockets 0.18 µm CMOS technology 3.3V operation with 5V I/O signal tolerance Provide Serial Peripheral Interface (SPI MODE...

Reference: RBD-2489

Wiznet W5500 Mini Ethernet Network Module

1 review

Wiznet Compact W5500 Network Module - 10/100 Base T WIZ850io is a compact size network module that includes a W5500 (TCP/IP hardwired chip and PHY embedded), a transformer and RJ45. It can be used as a component and no effort is required to interface W5500 and Transformer. The WIZ850io is an ideal option for users who want to develop their Internet...

Reference: RBD-2490

Arduino Ethernet Shield W5100 R3

1 review

Support TCP/IP protocol: TCP, UDP, ICMP, IPv4 ARP, IGMP, PPPoE and Ethernet Built-in 10BaseT/100BaseTX Ethernet physical layer Support automatic communication handshaking(full duplex and half duplex), Support automatic MDI/MDIX, automatically revise signal polarity Support ADSL connection (support PAP/CHAP certification mode in PPPoE protocol), Support...

Reference: RBD-2505

RS232 Bluetooth Serial Adapter Communication Master-Slave Module

RS232 Bluetooth Serial Adapter Communication Master-Slave Module

Reference: RBD-2545

Quectel EC200A-CN LTE Cat4 Module GSM GPRS MINI 4G To RJ45 Kit With 100M Ethernet Port

Quectel EC200A-CN LTE Cat4 Module GSM GPRS MINI 4G To RJ45 Kit With 100M Ethernet PortEC200ACNDA: (China and India) FDD: B1/B3/B5/B8 TDD:B34/B38/B39/B40/B41 WCDMA:B1/B5/B8 GSM:B3/B8 IPEX1 generation 4G antenna interface

Reference: RBD-2562

Open Smart Long Range 433Mhz RF Wireless Transceiver Kit For Arduino

The kit includes one pair of transmitter and receiver modules for increasing the communication distance. And the frequency is 433MHz. It is very popular for remote control systems, such as wireless doorbell, remote control rolling gates, smart car, smart home, etc.