Reference: RBD-0335

E-TECH SimonK 30A Brushless ESC Speed Controller

Features: Simonk Programe, Perfect drive Low voltage, over heat protection, with power on self detection function MCU and BEC with independant regulator, high anti-interference ability Throttle stroke adjustable, compatiable with different receivers, good low speed performance

Reference: RBD-0381

APM 2.6 Pixhawk Power Module V1.0

5 reviews

Operating Voltage:6~28 VDC Max Input Voltage:28 V DC Max Current Sensing: 90 A Connecting Type:XT-60 RoboticsBD

Reference: RBD-2352

HLK-LD2410B with BLE 24GHz mmWave Intelligent Switch Human Presence Sensing Radar Module

LD2410B is a high-sensitivity 24GHz human presence status sensing module developed by Hilink Electronics. Its working principle is to use FMCW frequency-modulated continuous wave to detect human targets in the set space. Combined with radar signal processing and accurate human body sensing algorithms, it realizes high-sensitivity human presence status...

Reference: RBD-0189

Brand: DFRobot

Xbee Shield for Arduino (without Xbee)

Xbee Shield for Arduino (without Xbee) INTRODUCTION: The XBee Expansion Board is a compliant solution designed to meet low-cost, low-power wireless sensor networks with special needs.The module is easy to use, low power consumption, and the provision of critical data between devices reliable transmission.

Reference: RBD-2295

CC2530+CC2591 Zigbee Module Wireless Power Amplification Development Board with SMA Antenna

The CC2530 ZigBee series wireless module launched by BEE Iot Technology is a ZigBee RADIO frequency module developed based on TI's CC2530F256 chip. The module can complete ZigBee learning, project application, and industrial production, and can be widely used in the field of short-distance wireless communication networking. It can build powerful network...

Reference: RBD-0574

Honeywell HMC5983 Temperature Compensated Three-Axis Digital Compass

3-Axis Magnetoresistive Sensors and ASIC in a 3.0x3.0x0.9mm LCC Surface Mount Package Temperature Compensated Data Output and Temperature Output Automatic Offset Compensation. RoboticsBD

Reference: RBD-2505

RS232 Bluetooth Serial Adapter Communication Master-Slave Module

RS232 Bluetooth Serial Adapter Communication Master-Slave Module

Reference: RBD-2513

5V Electromagnet - 25 Kg Holding Force - P40/20

Nominal Voltage: 5V DC Current Draw: 0.6 Amps at 5V Holding Force: 25 Kg / 55 lb Approximate Pickup Weight: 5 KgEver wanted to feel like Magneto? Well, now you sort of can! Bring the ferromagnetic objects in the world under your control with an Electromagnet The simplest way to make an electromagnet is to get a solenoid, pass some current through it, and...

Reference: RBD-0195

Brand: RoboticsBD

25mW Infrared Line Laser Light

25mW Infrared Line Laser Light

Reference: RBD-2514

5V Electromagnet - 10 Kg Holding Force - P30/22

Nominal Voltage: 5V DC Current Draw: 0.6 Amps at 5V Holding Force: 10 Kg / 22 lb Approximate Pickup Weight: 2 Kg / 4 lbEver wanted to feel like Magneto? Well, now you sort of can! Bring the ferromagnetic objects in the world under your control with an Electromagnet The simplest way to make an electromagnet is to get a solenoid, pass some current through...

Reference: RBD-2563

Flywing 30A 2s-3s Brushless ESC 1000KV-1400KV 5V/2A for RC Airplane

Introducing the FLYWING Brushless ESC, a high-performance electronic speed controller designed for RC airplane models and hobby planes. This ESC offers reliable and top-quality components to enhance the overall performance of your RC aircraft.

Reference: RBD-2372

RFID Reader Module 125KHz TK4100 RF UART IO Output Board For Access Control

This product is an ID card decoding module. After sensing the ID card, it will actively decode and output the 10-digit card number. It also has an output port that can output high and low levels, which can meet the requirements of general ID cards, such as reading, deleting, and registering. Card operation!

Reference: RBD-2515

5V Electromagnet - 5 Kg Holding Force - P25/20

Nominal Voltage: 5V DC Current Draw: 0.6 Amps at 5V Holding Force: 5 Kg / 11 lb Approximate Pickup Weight: 1 Kg / 2 lbEver wanted to feel like Magneto? Well, now you sort of can! Bring the ferromagnetic objects in the world under your control with an Electromagnet The simplest way to make an electromagnet is to get a solenoid, pass some current through...

Reference: RBD-2414

Yahboom 4 Channel Infrared Line Following Tracking Sensor Module

1 review

This tracking module adopts four tracking probes, and optimized spacing layout. The inner two probes can accurately identify the black line. The outer two probes can assist the inner probe to identify the black line and provide early warning. The car can recognize the 90°curved road and other difficult tracks. Knob-type adjustable resistors plus...

Reference: RBD-2518

Plastic Water Solenoid Valve - 12V - 1/2" Nominal

1/2" Nominal NPS Working Pressure: 0.02 Mpa - 0.8 Mpa Working Temperature: 1 ℃ - 75 ℃ Response time (open): ≤ 0.15 sec Response time (close): ≤ 0.3 sec Actuating voltage: 12VDC Actuating life: ≥ 50 million cycles

Reference: RBD-2533

QTR-8A Reflectance Sensor Array

2 reviews

This sensor module has 8 IR LED/phototransistor pairs mounted on a 0.375" pitch, making it a great detector for a line-following robot. Pairs of LEDs are arranged in series to halve current consumption, and a MOSFET allows the LEDs to be turned off for additional sensing or power-savings options. Each sensor provides a separate analog voltage output.Note:...

Reference: RBD-2327

Brand: DFRobot

Self-powered Wireless Switch 433Mhz

In life, remote controllers can be seen everywhere, and most of them are inseparable from the battery. However, we often encounter problems when using the battery, for instance, it is troublesome to replace the battery, batteries are easy to corrode in a humid environment, or the waste batteries may cause serious environmental pollution. Do you know that...

Reference: RBD-2508

ENS160 AHT21 Carbon Dioxide CO2 eCO2 TVOC Air Quality Temperature & Humidity Sensor

The ENS160 is a digital multi-gas sensor specifically designed for indoor air quality testing that optimizes the detection of a wide variety of gases and volatile organic compounds (VOCS), including toluene, hydrogen, ethanol, N02 and ozone. The air quality sensor is used in home and building automation, consumer products, electrical and air purification

Reference: RBD-2560

Open Smart PM2.5 Optical Powder Smoke Detector Module With Adapter For Arduino

Introducing the Dust Sensor - an optical sensing system designed for detecting airborne dust particles using an infrared emitting diode (IRED) and a phototransistor. The diode and phototransistor are diagonally arranged to effectively capture reflected light from dust in the air. Notably, this sensor is highly efficient in detecting very fine particles,...

Reference: RBD-2507

GY-US42 V2 i2c Pixhawk APM Flight Control Ultrasonic Distance Measurement Module

Reference: RBD-2683

XH-M452 Temperature and Humidity Control Module with Digital Display

XH-M452 DC 12V LED Digital Thermostat Temperature Humidity Control Module The XH-M452 temperature and humidity control module is a versatile and precise solution for temperature and humidity regulation in various applications. With a power supply of DC 12V, this module offers reliable performance and accuracy. Key Specifications: Power supply: DC 12V...

Reference: RBD-0341

Tiger LiPo Battery 1100mAh 3S 25C

Specification: battery Capacity : 1100mahbattery Voltage : 11.1 VoltBattery Size : 62*32*25 mmBattery Weight : 84 GramMax continuous discharge : 25CCharge Plug/Discharge Plug : XT60

Reference: RBD-2359

CC1101 500kbps Wireless Transceiver Module RF 433mhz SPI Interface SMA Antenna

This is a self-developed, small-size, 433 MHz DIP wireless module with a maximum tx power of 10mW based on CC1101 of Texas Instruments. Due to the adoption of the very mature CC1101 as the core chip, its stability has been unanimously praised by user. The module is mainly used in smart home, industrial, scientific research and medical, as well as...

Reference: RBD-2318

Sound Output Module Speaker Module Microphone Sensor Module Sound Sensor for Arduino

The Speaker module is composed of a power amplifier and a loudspeaker. Sound size can be adjusted by the potentiometer on the circuit board. Enter different frequencies, the speakers produce different tones. Can be carried out by for Arduino encoding and DIY their music box!Product data interfaceusing anti plug,the two sides of the interface are...

Reference: RBD-2774

FPV Head Tracker Dual Axis Servo Gimbal Bracket

Enhance your DIY RC robot or FPV setup with the FPV Head Tracker Dual Axis Servo Gimbal Bracket. This dual-axis servo gimbal bracket is designed to securely hold your camera in place, allowing for stable and precise positioning during operation. Crafted from lightweight aluminum alloy, this bracket ensures durability without adding unnecessary weight to...

Reference: RBD-2315

Pogo Pin Probe Clip - 6 Pins with 2.54mm

1 review

Pin Pitch: 2.54mm Probe model: P75-E2 (pointed tip) Needle diameter: 1.3mm Needle sleeve model R75-3W Row pin number: 6Pin Row Number: Single row space between: 2.54mm

Reference: RBD-2346

HW-671 WCS1800 Hall Current Sensor Over-current Protection Module Detection

HW-671 WCS1800 Hall Current Sensor Over-current Protection Module Detection

Reference: RBD-2396

GPS Module NEO-7M Satellite Positioning Module for Arduino with MicroUSB

1 review

GPS Module NEO-7M Satellite Positioning Module for Arduino with MicroUSB

Reference: RBD-2397

GPS Module NEO-6M Satellite Positioning Module for Arduino with MicroUSB

2 reviews

GPS Module NEO-6M Satellite Positioning Module for Arduino with MicroUSB

Reference: RBD-2541

Brand: DFRobot

Gravity: Voice Recorder Module

This is the latest voice recorder module with integrated record and play functions. Easily record your voice by pressing the record button, speaking and then releasing the button when finished. The module is able to playback 10 seconds in total. Connect an 8Ω 3W speaker or an external active speaker for voice output. The module also has a 3 pin digital...

Reference: RBD-2329

LSM6DS3TR-C IMU 3D digital Accelerometer & Gyroscope Module

The LSM6DS3TR-C is a system-in-package featuring a 3D digital accelerometer and a 3D digital gyroscope performing at 0.90 mA in high-performance mode and enabling always-on low-power features for an optimal motion experience for the consumer.

Reference: RBD-2347

TSL2591 High Dynamic Range Digital Light Sensor

TSL2591 Digital Light Sensor Breakout Module High Dynamic Range Lux IR Infrared Full Spectrum Diodes Detect 3.3V for Arduino