USB Host Shield For Arduino UNO, MEGA, Compatible with Google Android ADK

Force Sensitive Resistor 0.5"

TECHNICAL DETAILS Thickness: 0.4mm Trigger Force: 20g, triggered (default resistance<200kΩ) Pressure Measuring Range: 20g~6kg Static Pressure & Dynamic Pressure Measurement (within the frequency of 10Hz) Initial Resistance: >10MΩ Activation Time: <0.01S Operating Temperature: -40°C~+85°C Lifespan: >1million times Hysteresis: +10%，(RF+...

AC Light Dimmer Module, 2 Channel, 3.3V/5V logic, AC 50/60hz, 220V/110V

AC Light Dimmer Module, 2 Channel, 3.3V/5V logic, AC 50/60hz, 220V/110V General information This is the good old AC Dimmer, but with 2 channels. This one also can control the alternating current voltage in the same way. It can be used with lamps, elements, fans, pumps, air cleaners etc. So it’s the same thing, but twice bigger. In the tutorial, you can...

5.8GHz Circular Polarized Mushroom Antenna RP-SMA Set Tx/Rx for FPV Multicopter

Specifications:- Gain: 2.0dBi-2.5dBi- Standing-wave ratio (SWR): <1.5- Directivity: Omni-directional- Center frequency: 5.8Ghz- Connector: RP-SMA- Diameter of connector: 7.67mm- Length:Transmitter antenna:71mm- Receiver antenna:91mm- Net weight: 12g（Tx/Rx）- Package weight:69 g

Double-ended 50cm Cable Crocodile Clips

 Double-ended 50cm Cable  Crocodile Clips 5 colour available Red, Black, White, Green, Yellow.

Arduino Android IOS HM-10 BLE Bluetooth 4.0 CC2540 CC2541 Serial Wireless Module

This small size Bluetooth 4.0 TTL transceiver module allows your target device communicate with. your iPhone/iPAD, IOS 6 or Android 4.3 above devices. It's easy to use and completely encapsulated. You can set it as slave or master.You can use AT command set the baudrate.

Standard LCD 16x2

Standard LCD 16x2

GY-801 - Multi Sensor Board

GY-801  Multi-Sensor Board - 3 Axis Gyro -3 Axis  Accelerometer - 3 Axis Magnetometer, Barometer, Thermometer

Dupu Nano Li-po Battery 2200mAh 11V 3S 20C

Specification: - Weight: 176g- Size: 21*32*107mm- Single rated voltage: 3.7V- Single full charged voltage: 4.2V- Battery pack rated voltage: 11.1V- Battery full charged voltage: 12.6V- Continuous discharge rate: 20C- Battery pack rated capacity: 2200mAH- Cell material: Nano li-polymer

Waterproof DS18B20 Digital Thermal Probe or Sensor

This is a pre-wired and waterproofed version of the DS18B20 sensor. Handy for when you need to measure something far away, or in wet conditions. While the sensor is good up to 125°C the cable is jacketed in PVC so we suggest keeping it under 100°C. Because they are digital, you don't get any signal degradation even over long distances!

Jumper Wire Single Medium

Length: 8.5 inches (Medium) Material: Copper Plated.EachPin Spacing: 2.54mm.Color: Colorfulcompatible with 2.54mm mil spacing pin headers.It can be used for PCB project, pc motherboard, etc.Allow you to plug and unplug easily for prototyping.Package Contents: 1 x Jumper Wire You will get only one pcs.

18 DOF Aluminium Metal Hexapod Robot Spider Six Foot/Feet Robotic Frame/Chassis Kit

18 DOF Aluminium Metal Hexapod Robot Spider Six Foot/Feet Robotic Frame/Chassis Kit

Mini Breadboard

Description: This black Mini Breadboard is a great way to prototype your small projects! With 170 tie points there’s just enough room to build and test simple circuits; They’re also great for breaking out DIP package ICs to jumper wires! If you run out of room, no worries, these mini breadboards can be snapped together to form larger stretches of board...

433Mhz Wireless Serial Transceiver Module - 1 Kilometer

Long-distance wireless transmission 3 working modes Working frequency range (433.4-473.0MHz, up to 100 communication channels) Built-in MCU, performing communication with external device through serial port

Mini Servo SG90

Getting an original TowerPro Servo Motor is not an economical option at all!!! And is also a very difficult task to recognize and buy an original TowerPro servo, Because there are many suppliers spread over different online shops who are selling fake servo motors under this Brand name. We have imported this copy of the original TowerPro SG90 9g Mini...

RGB Full color LED SMD Module

The KY-009 RGB Full Color LED SMD Module consists of a 5050 SMD LED, use with limiting resistors to prevent burnout. Compatible with popular electronics platforms like Arduino, Raspberry Pi and ESP8266. RGB full color LED Module KY-009 for Arduino, emits a range of colors by mixing red, green and blue. The amount of each primary color is adjusted using PWM.

Digispark Kickstarter ATTINY85 Arduino General Micro USB Development Board

Digispark USB Development Board The Digispark is an Attiny85 based microcontroller development board similar to the Arduino line, only cheaper, smaller, and a bit less powerful. With a whole host of shields to extend its functionality and the ability to use the familiar Arduino IDE the Digispark is a great way to jump into electronics, or perfect for when...

LCD Keypad Shield for Arduino

LCD keypad shield for Arduino operates at 5V Includes a 2x16 LCD display and 6 momentary push buttons Use digital pins 4, 5, 6, 7, 8, 9, 10, and analog pin 0 to interface with the LCD Do not use Pin 10 while this shield is connected LCD color may vary (green or blue)

Male Pin Header Single Row (L Shaped)

Male Pin Header Single Row (L Shaped) (40 Pin Set)

Brand: DFRobot

Dual Bipolar Stepper Motor Shield for Arduino (A4988) With Xbee Communication Socket

INTRODUCTION Do you want to do some projects with stepper motors suchas an auto curtain, a XY Plotter, or a 3D printer? Generally, it's not an easy thing todrive stepper motor(s) with Arduino; but with this stepper motor shield, you can easily control 2 stepper motors via just 4 digital I/O’s. This board is  

Brand: RoboticsBD

3D Printed Robotics claw with servo motor

Description: Material: PLA (3D Printed)Claw max angle: 55mmLength: 108mmWidth: 98mm (streched)Color: Golden, Blue, Red Servo Motor: MG996R

Reference: Sparkfun

XBee 1mW Trace Antenna - Series 1 (802.15.4)

Description: This is the very popular 2.4GHz XBee module from Digi. These modules take the 802.15.4 stack (the basis for Zigbee) and wrap it into a simple to use serial command set. These modules allow very reliable and simple communication between microcontrollers, computers, systems, really anything with a serial port! Point to point and multi-point...

Brand: SparkFun Electronics

EL Wire - Starter Kit Retail

YF-S201 Hall Effect Water Flow Meter / Sensor

Features: Model: YF-S201 Sensor Type: Hall effect Working Voltage: 5 to 18V DC (min tested working voltage 4.5V) Max current draw: 15mA @ 5V Output Type: 5V TTL Working Flow Rate: 1 to 30 Liters/Minute Working Temperature range: -25 to +80℃ Working Humidity Range: 35%-80% RH Accuracy: ±10%

WiDo - Arduino WIFI IoT Node

WiDo - Arduino WIFI IoT(Internet Of Things) Node (Arduino Compatible) Wido is an Arduino compatible WIFI IoT Node development board, which integrates with WG1300 WIFI solution. The microcontroller of Wido is ATMEL ATmega32U4.

Brand: SparkFun Electronics

EasyVR Shield 3.0 - Voice Recognition Shield

Description:  Do you make time to talk to your Arduino? Maybe you should! The Easy VR Shield 3.0 is a voice recognition shield for Arduino boards integrating an EasyVR module. It includes all of the features of the EasyVR module in a shield form factor that simplifies connection to the Arduino main board and PC.

2-Axis FPV Nylon PTZ Pan/Tilt Anti-Vibration Camera Platform

Mini 2-Axis platform for camera Weight: 20gsuitable for 9g-12g servos or MG90, MG90S, SG90precision and great appearanceit’s a very stable platform for camera

Arduino GSM / GPRS / GPS Shield

Overview GSM/GPRS/GPS Shield is an Arduino shield based on the Quad-band GSM/GPRS/GPS module SIM908.

Precision Real Time Clock Module DS3231 AT24C32 I2C

Precision Real Time Clock Module DS3231 AT24C32 I2C

Lynxmotion AL5D 4DOF Robotic Arm SSC-32U Combo Kit (FlowBotics Studio)

AL5D arm with SSC-32U USB board and powerful PC software Advanced inverse kinematics positioning control using mouse Includes license for full version of FlowBotics Studio Programming Software Wrist rotate sold separately (three options)  

RC04A Chassis Kit Double Deck (12V, 300RPM)

RC04A Chassis Kit Double Deck with Motor Set Item Included:  Pololu 5" Robot Chassis RRC04A Base 5" Robot Top N20 Gear Motor (12V, 300 RPM) Caster Ball