PIR Motion Sensor

Reference: RBD-1195

TSOP1736 IR Receiver

Temperature Coefficient Type: NTC Thermal Time Constant: 10s Resistance  10kΩ Tolerance: ±1%

Reference: RBD-1177

4-20mA Signal Generator Current Loop Simulator Tester

This signal generator can use 4-20mA to generate voltage and control the current in the circuit. Accuracy up to 0.01; Liquid crystal display; Rotary encoder adjustment ; Two connection terminals are non polarity. Output range can be set; 4-20mA (device control) / -21mA (signal debugging) Display mode can be set, it is convenient for you to see the value...

Reference: RBD-0574

Honeywell HMC5983 Temperature Compensated Three-Axis Digital Compass

3-Axis Magnetoresistive Sensors and ASIC in a 3.0x3.0x0.9mm LCC Surface Mount Package Temperature Compensated Data Output and Temperature Output Automatic Offset Compensation. RoboticsBD

Reference: RBD-1976

OV2640 2.0 Mega Pixel 1/4'' CMOS Image Sensor Camera Module

Suitable for ESP32 CAM

Reference: RBD-0674

MQ-5 Smoke Gas Detector Sensor

Model: MQ-5 Operating Voltage: 5V DC Operating Temparature:-20~40 degree celcius

Reference: RBD-1728

IR Digital 38khz Infrared Receiver Sensor Module

IR Digital 38khz Infrared Receiver Sensor Module

Reference: RBD-0491

Omron Proximity Sensor Switch Omron E2E-X5ME1

Sensor Type: Inductive Sensing Distance: 0.197" (5mm) Output Type: NPN-NO, 3-Wire Response Frequency: 400Hz

Reference: RBD-0554

GY-VL53L0XV2V VL53L0X Time-of-Flight Distance Sensor Breakout Module

VL53L0X 3-in-1 ranging and gesture detection sensor Regulator: 5 to 2.8V range input voltage (output voltage: 2.8V) VL53L0X signal interface level shifter Serial Port PWM Output True distance measurement independent of target size and reflectance Breakout board, easy to integrate into the customer device Allows basic gesture recognition use case. RoboticsBD

Reference: RBD-0679

MQ-135 Gas Sensor

Sensitivity to Ammonia, Sulfide and Benzene steam Sensitive for benzene, alcohol, smoke Fast response and recovery Adjustable sensitivity. RoboticsBD Signal output indicator Output voltage boosts along with the concentration of the measured gases increases.

Reference: RBD-0149

Flame Sensor fire detection module for Arduino

Output Channel: 1 Power Supply: 3.3/5V Built in a potentiometer for sensitivity control. Onboard signal output indication, output effective signal is high, at the same time the indicator light up, the output signal can directly connect to microcontroller IO. Detection angle about 60 degrees, the flame spectrum especially sensitive. The flame of the most...

Reference: RBD-1374

DHT21 AM2301 Temperature & Humidity Sensor

Model: AM2301. Supply voltage: 3.3 ~ 5.2 V DC. Signal output form: Digital signal output. Temperature measurement range: -40 ~ +80 ºC. Temperature measurement precision: ± 0.5ºC Humidity range: 10%~90%RH. Humidity measurement precision: ±3%RH.

Reference: RBD-1422

Pixy2 CMUcam5 Smart Vision Sensor

Processor: NXP LPC4330, 204 MHz, dual core Image sensor: Aptina MT9M114, 1296×976 resolution with integrated image flow processor Lens field-of-view: 80 degrees horizontal, 40 degrees vertical Power consumption: 140 mA typical Power input: USB input (5V) or unregulated input (6V to 10V) RAM: 264K bytes Flash: 2M bytes

Reference: RBD-1423

Raspberry Pi High Quality Camera with 6mm Lense

Sony IMX477R stacked, back-illuminated sensor. Resolution: 12.3 megapixels. Compatible with Raspberry Pi 1/2/3/4 boards Output: RAW12/10/8, COMP8 Back focus: Adjustable (12.5 mm–22.4 mm) Lens standards: C-mount, CS-mount (C-CS adapter included) IR cut filter: Integrated Wide Field of View suitable for CCTV applications Suitable for macro photography...

Reference: RBD-0569

MPU9250 9-Axis Attitude Gyro Accelerator Magnetometer Sensor Module

Acceleration, Gyroscope, and Magnetometer Power Supply: DC3.3V-5V Chip: MPU9250 Size: 22 mm x 17 mm. Gyro range : ± 250 500 1000 2000 ° / s Acceleration range: ± 2 ± 4 ± 8 ± 16g Magnetic field range: ± 4800uT 9 DOF modules

Reference: RBD-0677

MQ-8 Hydrogen Gas Sensor

Using high-quality dual-panel design, with power indicator and TTL signal output instructions. The switching signal having a DO (TTL) output and analog output AO. TTL output valid signal is low. The higher the voltage, the concentration of the analog output voltage is higher. A hydrogen gas detection with good sensitivity. Has a long life and reliable...

Reference: RBD-1206

RPLIDAR A2 360° Laser Range Scanner

Scanning Range: 18M Radius Detection Range:  12M Radius 4cm Ultra-thin Ideal for all kinds of service robot. 8000 times sample rate, the highest in the current economical LIDAR industry 360-degree laser range scanning Low Noise, Brushless Motor New Non-contact Drive OPTMAG Original Design, prolong the life-span Class 1 Laser Safety Standard High-speed...

Reference: RBD-1179

LM35 Temperature Sensor Waterproof

Temperature measuring range: 0...100°C Typical Input Voltage:3.3VDC,5VDC Operating Current:60uA Interface: Analog

Reference: RBD-0948

ESP32 ESP-32S 30P NodeMCU Development Board Wireless WiFi

Built-in Flash: 32Mbit Power supply: 5V WiFi protocol: IEEE 802.11 b/g/n Peripheral interface: UART/GPIO/ADC/DAC/SDIO/PWM/I2C/I2S Logic level: 3.3V

Reference: RBD-0233

Brand: SparkFun Electronics

SparkFun 9 Degrees of Freedom IMU Breakout - LSM9DS0

Description: This is the LSM9DS0, a versatile motion-sensing  system-in-a-chip that houses a 3-axis accelerometer, 3-axis  gyroscope, and 3-axis magnetometer. That’s right, 9 degrees  of freedom (9dof) from a single IC!

Reference: RBD-0691

IR Infrared Remote Decoder Encoding Transmitter & Receiver Wireless Module

Supply voltage: 5V Communication: Serial communication (TTL level) Operating istance: 6-10 meters 

Reference: RBD-0147

HR202 Humidity Detection Sensor Module

Adjustable Sensitivity, External GND. Detect Ambient Humidity. Provided with Fixed Bolt Hole, Convenient to Install. Power Indicator Light & Digital Output Indication Lamp. Using LM393 Chip for Stable Work. DO Small Digital Outputs Interface (0 & 1).

Reference: RBD-338

Brand: Waveshare

Dust Sensor For Arduino

Dust Sensor, A simple Air Monitor Overview Sharp GP2Y1010AU0F onboard, detecting fine particle larger than 0.8μm         in diameter, even like the cigarette smoke Low power consumption, analog voltage output, the output level is linear         with dust density Embedded voltage boost circuit to support wide range of power supply

Reference: RBD-1931

Soil NPK Sensor Agricultural RS485/Modbus

3 in1 Soil NPK Sensor PH temperature humidity Conductivity EC Sensor RS485 DC power supply (default) DC 5-30V Maximum power consumption ≤0.15W (@12V DC, 25℃) Operating temperature 0℃~55℃ Nitrogen phosphorus potassium range: 1-1999 mg/kg (mg/L); resolution rate: 1 mg / kg (mg / L), accuracy of: ± 2% FS Response time <1S Protection IP68 Probe materials...

Reference: RBD-1424

ZMCT103C 5A Range Single Phase AC Micro Current Transformer Sensor

Onboard precision microcurrent transformer. Onboard sampling resistor. The module can measure AC currents less than 5A, the corresponding analog output 5A/5mA. Rated input current: 5A Rated output current: 5mA Change: 1000: 1 The linear range: 0 ~ 10A (100 ohms) Linearity: 0.2%

Reference: RBD-0424

Si7021 Industrial High Precision Humidity Sensor I2C Interface for Arduino

Wide operating voltage (1.9 to 3.6 V) – 3.3 V Recommended Precision Relative Humidity Sensor ± 3% RH (max), 0–80% RH High Accuracy Temperature Sensor ±0.4 °C (max), –10 to 85 °C Interchangeable - No recalibration required. RoboticsBD I2C Interface

Reference: RBD-0668

DS1302 Real Time Clock Module (DS1302Z clock chip,32.768KHZ crystal)

Crystal 32.768KHz, matching capacitance 6pF DS1302 8-pin SMD homemade chips Seconds, Minutes, Hours, Day of Month, Day of Week, and Year Operating temperature: 0 degree — 70 degree. RoboticsBD

Reference: RBD-0797

U-Blox NEO-6M GPS Module

5Hz position update rate. The cold start time of 38 s and Hot start time of 1 s. Configurable from 4800 Baud to 115200 Baud rates. (default 9600). SuperSense ® Indoor GPS: -162 dBm tracking sensitivity. Support SBAS (WAAS, EGNOS, MSAS, GAGAN). Separated 18 x 18mm GPS antenna. RoboticsBD In recent years 2022, due to a shortage of chips, some of the GPS...

Reference: RBD-1049

Humidity Detection Sensor Module Snow Rain Raindrops Detection For Arduino

Operating voltage: 5V Provide both digital and analog output Adjustable sensitivity Output LED indicator Compatible with Arduino TTL Compatible Bolt holes for easy installation

Reference: RBD-0307

MLX90614 Contactless Temperature Sensor Module For Arduino

Operating Voltage(V): 3- 5 Operating Current(mA): 2 Communication protocol: I2C Power saving mode Automotive grad Small size, low cost. RoboticsBD

Reference: RBD-1866

PIR Sensor 360 Degree Ceiling Mounted

 High Sensitivity PIR Sensor 360 Degree IR Infrared Motion Sensor Light Switch AC 110V-240V Ceiling Recessed PIR Switch Detector